Overview
The G2 Axle and Gear CORE 44 rear axle assembly, part number G/2C4TSR488LC0D, has a 4.88 gear ratio and a Detroit Locker, with a disc brake kit. G2 introduces the CORE 44 for 1997-2006 Jeep TJ/LJ Wranglers, and this rear is the 4.88 ratio, locker-equipped version for those years.
The CORE 44 uses a high pinion Dana 44 gear design, built to handle loads that would bend a stock Dana 30 or a Rubicon Dana 44. The housing accepts stock Dana 44 ring and pinions, axle shafts and all aftermarket lockers.
The Detroit Locker gives the rear a locking differential, and the disc brake kit is part of the rear package. Axle shafts are 30 splines, and the wheel bolt pattern is 5 on 4.5 inches.
Key features
- CORE 44 rear housing, high pinion Dana 44 gear design
- Detroit Locker locking differential
- Disc brake kit
- 4.88 gear ratio
- 30 spline axle shafts
- 5 on 4.5 inch wheel bolt pattern
Choosing a locker setup
A locking rear changes how the axle behaves on loose or uneven ground. With a locker engaged, both wheels turn together, which helps when one tire lifts off the surface. The trade-off is tighter turns on pavement, where a locker can cause hopping or chatter. Many owners keep the locker engaged only on trails and release it for road driving.
Because the gears are set for a 4.88 ratio, the axle works harder at low speed and the engine turns faster at a given road speed. Larger tires shift that balance further, so matching gearing to tire height matters. Ring and pinion replacement and locker installation are often done together, since the carrier has to come out either way.
- Check tire diameter before choosing final drive
- Inspect locker engagement after the first trail runs
- Replace pinion seals when the carrier is opened
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | G/2C4TSR488LC0D |
| Axle type | CORE 44 rear, high pinion Dana 44 design |
| Housing type | 97-06 Jeep TJ Dana 44 |
| Position | Rear |
| Gear ratio | 4.88 |
| Axle spline | 30 splines |
| Traction device | Detroit Locker |
| Brakes | Disc brake upgrade |
| Wheel bolt pattern | 5 on 4.5 inches |
Vehicle fitment
The rear fits the 1997–2006 Jeep TJ and the 2004–2006 LJ Wrangler. The housing is a 97-06 Jeep TJ Dana 44.
This rear is for the 1997–2006 TJ and 2004–2006 LJ Wranglers. Confirm fit for your vehicle’s year, model and trim before ordering, especially for the 1987–1995 YJ, 1984–2001 Cherokee XJ or 2007–2018 JK.
Installation notes
A Detroit Locker with a 4.88 ratio needs ring and pinion setup and bearing preload set by a shop with gear setup equipment. The disc brake kit is part of the rear package and should be fitted with the axle, not added afterward.
What’s included
The CORE 44 rear axle assembly with the Detroit Locker and the disc brake kit.
Not included: Check the package contents against your installation before starting, including whether axle shafts and ring and pinions are present.














