Overview
The Fabtech FTS50412 is a large 5 ton arm joint for the 2007–2018 Jeep Wrangler JK. It has a heavy forged steel housing that holds a proprietary spherical bearing, and the bearing is designed for a quiet ride on the highway.
The joint has high misalignment, with 33 degrees of angle, and a 1 inch ball with a 1.50 inch diameter thread. The spherical bearing is designed for 5 ton medium truck applications.
Key features
- Heavy duty forged steel housing
- Proprietary spherical bearing
- Quiet ride bearing liner
- High misalignment, 33 degrees of angle
- Polished and plated housing
Arm joints and wear
Arm joints connect the control arm or track bar to the axle and let the suspension move through its travel without binding. As they wear, play develops at the joint, the steering can feel loose and the arm may clunk over bumps. Off-road articulation puts extra load on these joints, so checking them after trail use helps catch wear early.
When replacing an arm joint, inspect the mounting bolts, the adjacent arm and the seals at the same time. Mismatched wear between joints can change the arm geometry, so replacing joints as a pair often keeps the suspension behaving evenly. Set the alignment once the new joint is installed and torqued.
- Check for play by hand at the joint
- Inspect seals and boots for tears
- Replace joints in pairs when wear is similar
- Re-check torque after the first trail runs
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FABFTS50412 |
| Joint rating | 5 ton |
| Angle | 33 degrees |
| Ball size | 1 inch |
| Thread | 1.50 inch diameter |
| Housing | Forged steel, polished and plated |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler JK in its 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims, in 2-door and 4-door form.
Wrangler JL and Gladiator models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The joint installs in the arm position for the JK suspension, and the ball and thread must match the arm. Because of the high misalignment rating, check the arm geometry and clearance after installation. Set the alignment after the joint is in place.









