Overview
The Dana Spicer 10010519 is an Ultimate Dana 44 front axle with a 3.73 ratio and a factory electric locker. It fits 2007-2016 Jeep Wrangler (JK) Unlimited models.
The axle is a direct bolt-in unit that reuses the stock wheel ends. It has 5/16 inch thick axle tubes, redesigned brackets and Spicer chromoly shafts, and it is built for serious off-road use.
The 3.73 gearing sits in a housing with a factory electric locker, and the SPL 1350 universal joints use triple lip seals and full-circle clips. Caster and pinion angle are improved for lifted Jeeps, and the axle carries an increased gross axle weight rating. Dana recommends military tested and approved 75W-140 synthetic lube, which is not included with the axle.
The upgrades are aimed at on-trail durability and added strength wherever the Jeep is driven.
Confirm the axle position and wheel bolt pattern against your vehicle before installing.
Key features
- 3.73 gear ratio
- Factory electric locker, selectable electronic locking differential
- 5/16 inch thick axle tubes and redesigned, thicker brackets
- Spicer chromoly steel axle shafts
- Spicer Life Series 1350 u-joints with triple lip seals and full-circle clips
- Performance differential cover and Spicer performance gasket
- Improved caster and pinion angle for lifted Jeeps
Front axle upkeep
A Dana 44 front axle carries steering loads and drive torque at the same time, so its gear set, bearings and seals work hard on rough trails. The gearing and locker make a difference only if the axle is kept in good order. Keep the gear oil at the correct level, and watch the axle breather and seals for leaks after water crossings or steep descents.
The axle shafts and joints see the most stress when the locker engages. Inspect the u-joints, boots and shafts regularly, and check the wheel bearings and hub seals whenever the wheels come off. A locker that engages slowly or with a clunk may need its wiring or actuator checked before the next trip.
- Check gear oil level after the first drives
- Inspect u-joints and axle shafts for wear
- Look for leaks at the seals and breather
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 10010519 |
| UPC | 23913483692 |
| Position | Front |
| Housing | 07-up Jeep JK Dana 44 |
| Gear ratio | 3.73 |
| Traction | Factory electric locker |
| Brakes | Reuse factory |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007-2016 Jeep Wrangler (JK) Unlimited models, including the Unlimited Rubicon, Unlimited Sahara, Unlimited Sport, Unlimited Sport S, Unlimited X and Unlimited 70th and 75th Anniversary versions.
Two-door JK models are not in the list, and the JK range ends at 2016 here. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This Ultimate Dana 44 reuses the factory wheel ends, so check that the wheel bolt pattern is 5 on 5 inches before installing.
What’s included
The front axle assembly with the factory electric locker and Spicer chromoly shafts.
Not included: the 75W-140 synthetic gear lube that Dana recommends.











