Overview
The axle is a front Ultimate Dana 44 with a 4.56 ratio and a factory electric locker. It is a bolt-in replacement for 2007-2018 Jeep Wrangler JK models and reuses the stock wheel ends.
The axle is made for serious off-road use. It has 4.56 Genuine Spicer gears, 5/16 inch thick tubes and a performance differential cover.
The Ultimate Dana 44 is made for serious off-road use, with upgrades for on-trail durability. It is a direct bolt-in solution, and the stock wheel ends stay in place.
The 4.56 gears are Genuine Spicer gears. The SPL 1350 u-joints have triple lip seals and full-circle clips, the 5/16 inch thick axle tubes carry redesigned, thicker brackets, and the brakes are factory reuse.
Key features
- 4.56 Genuine Spicer gears
- Factory electric locker
- 5/16 inch thick axle tubes and thicker brackets
- Spicer chromoly axle shafts
- Spicer Life Series 1350 u-joints with triple lip seals and full-circle clips
- Performance differential cover and gasket
Gearing and tire choice
Axle gearing and tire size work together. Larger tires already turn the drivetrain more slowly for each mile, so a numerically higher ratio helps restore the lost pull and can make low-speed crawling feel more controlled. Fast highway cruising is the trade-off, since the engine turns faster at the same speed.
Before committing, consider how the Jeep is used day to day. A front axle change is easier to plan when the rear gears, transfer case ratio and tire diameter are already known. Once the swap is done, check the speedometer calibration, since the new ratio changes what it reads. Re-check the front axle mounting and steering geometry after the first few weeks of use.
- Measure your tire diameter before choosing a ratio
- Check the speedometer after the change
- Confirm the rear gears match the front ratio
- Re-check alignment after the first few weeks
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 10010520 |
| UPC | 23913483715 |
| Position | Front |
| Housing | 07-up Jeep JK Dana 44 |
| Gear ratio | 4.56 |
| Traction | Factory electric locker |
| Brakes | Reuse factory |
| Fitment type | Direct fit |
Vehicle fitment
This axle fits 2007-2018 Jeep Wrangler JK models in the front position, using the 07-up Jeep JK Dana 44 housing.
It is not made for the rear JK or for the Wrangler JL. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fit the axle onto the stock wheel ends, then check alignment and caster, since the caster and pinion angles are set for lifted Jeeps.
What’s included
The axle assembly with Spicer chromoly shafts and SPL 1350 u-joints.
Not included: gear lube and the locker harness.











