Overview
The Dana Spicer 10010522 is an Ultimate Dana 44 front axle assembly with a 5.13 ratio for 2007-2018 Jeep Wrangler JK models. It bolts in directly and reuses the stock wheel ends.
The axle uses 5/16 inch thick tubes and Genuine Spicer 5.13 gears, with Spicer chromoly axle shafts. Its caster and pinion angles are set for lifted Jeeps.
The stock wheel ends stay in use with this axle, so the hub side of the vehicle does not change. The upgrades are in the housing, gears, shafts and differential.
Key features
- Genuine Spicer 5.13 gears
- 5/16 inch thick axle tubes and redesigned, thicker brackets
- Spicer chromoly axle shafts and Spicer Life Series 1350 u-joints with triple lip seals
- Performance differential cover and Spicer performance gasket
- Selectable electronic locking differential, harness sold separately
- Improved caster and pinion angle for lifted Jeeps, with increased gross axle weight rating
Front axle upgrades to consider
A front axle swap changes more than the housing. The shafts, joints and gear set carry the load under power and during articulation, so the upgrades are chosen as a group. Matching the ring and pinion to the tire size and driving style helps keep gear noise and heat under control.
Locking differentials add traction but also add load to the axle and drivetrain. When adding a locker, plan for the harness, the control switch and the wiring to be installed together. Check the front driveline angles after any lift, since a change in ride height can increase u-joint wear.
- Confirm the locker harness and switch are installed together
- Check driveline angles after changing ride height
- Inspect axle seals and u-joints periodically
- Keep brake lines and the ABS sensor wiring clear of the axle
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 10010522 |
| UPC | 23913483739 |
| Position | Front |
| Housing | Ultimate Dana 44, 2007 and up JK |
| Gear ratio | 5.13 |
| Traction | Selectable electronic locking differential |
| Wheel bolt pattern | 5 on 5 inches |
| Brakes | Reuse factory |
| Locker harness | Part number D/S10021771, sold separately |
| Fitment type | Direct fit |
Vehicle fitment
Dana Spicer builds this axle for the Jeep Wrangler JK from 2007 through the 2018 model year, as a direct bolt-in front axle.
It is for the front position only, and it is not made for the Wrangler JL or the Gladiator JT. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The locker does not work without its harness, which is sold separately under part number D/S10021771.
What’s included
The assembly comes with the Spicer chromoly axle shafts, Spicer Life Series 1350 u-joints and the performance differential cover and gasket.
Not included: the locker harness and the 75W-140 synthetic gear lube that Dana recommends.













