Overview
The Bilstein 25-187793 is a rear 5160 Series reservoir shock absorber for the 2004–2006 Jeep Wrangler (LJ), including Unlimited and Unlimited Rubicon models, and the 1997–2006 Jeep Wrangler (TJ). It has bar mounts at both ends and fits the stock shock location, so no cutting or welding is needed.
A remote reservoir gives the shock more oil volume, and Bilstein links that volume to cooler running and steadier damping on rough terrain. The shock has 10.05 in of travel on a 14mm shaft, and the stated lift range of 5 – 5.5 in. makes it a rear option for lifted Wrangler builds.
Key features
- Bar mounts at both the lower and upper ends.
- Mono tube body with a 46mm ID smooth body in a non-coilover format.
- Remote reservoir for extra shock oil capacity during heavy use.
- Digressive valving that delivers full damping capability right away.
- Floating dividing piston inside the reservoir for more wheel travel and shaft movement.
- Zinc plated finish with Bilstein’s Triple-C Technology.
- Upper mount and reservoir mount included.
Reservoir placement and clearance
A remote reservoir needs its own clearance, so place the hose and mount where heat and debris are less likely to reach them. Keep the reservoir clear of frame rails, exhaust components and tire paths. Check the hose for kinks at full suspension compression, since a pinched line can change how the shock performs.
Larger lifts change the arc of the suspension, so the reservoir may need a new angle or a slight reposition to clear the body. Recheck clearance after the first articulation test on a trail, and inspect the hose and mount fasteners at each service interval.
- Check the hose at full compression
- Keep clear of exhaust and tires
- Recheck fasteners after the first trail run
- Confirm clearance after any lift change
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 25-187793 |
| UPC | 651860654829 |
| Series | 5160 Series |
| Position | Rear |
| Fitment type | Direct Fit |
| Collapsed length | 14.87 in |
| Extended length | 24.92 in |
| Travel length | 10.05 in |
| Lower mount | Bar mount |
| Upper mount | Bar mount |
| Shaft diameter | 14mm |
| Reservoir | Yes |
| Body design | 46mm ID smooth body (non-coilover) |
| Internal design | Mono tube |
| Finish | Zinc plated |
| Boot included | No |
| Lift height | 5 – 5.5 in lift |
| Hydraulic / gas charged | Gas charged |
| Mounting parts included | Upper Mount and Reservoir Mount |
Vehicle fitment
It fits the 2004–2006 Jeep Wrangler (LJ), including Unlimited and Unlimited Rubicon, and the 1997–2006 Jeep Wrangler (TJ), including 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X.
Wrangler JK models from 2007 onward and other generations are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The upper mount and reservoir mount are the included mounting parts, so bracket alignment and reservoir placement come first. Because the lift range is 5 – 5.5 in., recheck suspension geometry and driveline angles once the truck is set up. Keep the reservoir away from the frame and moving parts, then check that gap after the first drive.
What’s included
Upper mount, reservoir mount, reservoir mounting kit and detailed instructions.
Not included: Boot, since the shock is supplied without one.









