Overview
The Bilstein 5100 Series Shock Absorber, part number 24-185523, is a front gas-charged monotube shock with an eye lower mount and a stem upper mount, a 46mm ID smooth body and a 14mm shaft. It is rated for w/4 in. lift and fits several Ford models, detailed below.
The 5100 line is aimed at lifted trucks, Jeeps and prerunners. This front unit has a collapsed length of 12.17 in, an extended length of 18.98 in and 6.81 in of travel, which are the measurements to compare when matching a shock to a lift.
The 5100 design is single-tube with high gas pressure, self-adjusting deflecting disc valving and a high-flow piston that reduces harshness. It is built for large-diameter tires and specific lift kits, and it uses the factory O.E.M. mounting configuration.
Key features
- Monotube gas pressure construction
- Self-adjusting deflecting disc valving
- High-flow piston intended to reduce harshness
- Independent rebound and compression tuning
- Larger working piston area for damping control
- Built for large-diameter tires
Front shock setup and lift
A front shock manages wheel control, steering feel and body roll on the front axle. Its job changes once a lift raises the front end, because the extra height changes the angle of the upper and lower mounts. Confirm that your installed lift matches the rating before fitting, and check that the tire clears the shock body at full steering lock.
Front shocks are usually replaced in pairs so both sides damp the same way. While the old unit is off, inspect the bump stops, upper mounts and bushings, since worn rubber there can make a new shock work harder than it should. Keep brake lines and steering components clear of the body during installation.
- Check tire clearance at full left and right steering lock
- Inspect the bump stops for cracking or flattening
- Replace worn upper mount bushings before fitting
- Heat or pierce the pressurized body never; keep it intact
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-185523 |
| UPC | 651860453651 |
| Series | 5100 Series |
| Position | Front |
| Collapsed length | 12.17 in |
| Extended length | 18.98 in |
| Travel | 6.81 in |
| Lower mount | Eye, 16mm |
| Upper mount | Stem |
| Shaft diameter | 14mm |
| Body design | 46mm ID smooth body (non-coilover) |
| Internal design | Mono tube |
| Finish | Zinc plated |
| Reservoir | No |
| Boot | Included |
| Lift height | w/4 in. Lift |
| Charge | Gas charged |
| Fitment type | Direct Fit |
Vehicle fitment
It fits the Ford Bronco 1980–1996, Excursion 2000–2005, F-150 1980–2003, F-250 1980–1999, F-250 Super Duty 1999–2016, F-350 1980–1995 and F-350 Super Duty 1999–2016. Trim names vary by entry.
There are no F-150 entries after 2003, no Bronco entries after 1996 and no F-350 entries for 1996 through 1998.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The stated lift height is w/4 in. Lift, so measure your installed lift and confirm it matches before fitting this front shock. The lower eye mount is 16mm and the upper mount is a stem, so match those to your existing hardware. Heating or piercing the pressurized body is unsafe.
What’s included
Front shock absorber with boot.









