Overview
The Bilstein 24-014694 is a heavy duty 46mm monotube gas charged shock absorber for the rear of the 1990–1995 Toyota 4Runner (SR5). It belongs to Bilstein’s 4600 Series and is a direct fit replacement with no lift or drop (0 in. lift/drop).
Bilstein builds this shock around a single tube that carries heat from the damping oil out to the shock body. A dividing piston lets the oil expand as it warms, which limits foaming and viscosity loss so damping holds steady as temperatures climb. It suits a 4Runner owner replacing worn rear shocks with a yellow, heavy duty part that keeps the original mounting positions.
Key features
- Heavy duty 46mm monotube body with gas charged damping
- Dividing piston allows the oil to expand as heat builds, which Bilstein says prevents aeration and viscosity loss
- Seamless tube made by an extrusion method that Bilstein says holds a tight peak-to-valley tolerance
- Piston head lets compression and rebound damping be tuned separately
- Digressive piston design with fewer parts than conventional twin tube shocks
- Rear position, direct fit, yellow finish
Choosing a heavy duty rear shock
Heavy duty shocks are built for loads and rough use, and a rear unit controls the body’s motion over bumps and under braking. A monotube design keeps the damping oil cool and steady, which matters on long descents or repeated trail runs. When choosing a replacement, match the mount type and lengths to the original shock, since good damping does not correct a mismatch.
Rear shocks should be replaced in pairs so both sides damp the same way. Check the rear springs and bump stops when the shocks are swapped, since worn springs change how the shock works. Keep the body away from heat, and retighten the mounting hardware after the first few drives.
- Match mount type and length to the original
- Replace rear shocks in pairs
- Inspect rear springs and bump stops
- Retighten mounts after the first few drives
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-014694 |
| UPC | 651860652214 |
| Shock series | 4600 Series |
| Size and type | 46mm monotube |
| Gas charge | Gas charged |
| Position | Rear |
| Fitment type | Direct fit |
| Lift height | 0 in. lift/drop |
| Finish | Yellow |
| Old part numbers | BILF4-B46-1469-H0, BILF4-B46-1469-H1 |
Vehicle fitment
The fitment is 1990–1995 Toyota 4Runner (SR5) for this rear shock. It is a direct fit replacement, so it swaps in for the original rear shock without modification.
The list does not cover other 4Runner model years or other Toyota models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Keep a gas charged shock away from heat and do not cut or open the body. Compare the upper and lower mounting points with the shock being replaced before fitting the new unit.
What’s included
One Bilstein 46mm monotube shock absorber, part number 24-014694. No other pieces are named for this part.









