Overview
The Baer Brakes 6801311 is a kit of two polished stainless steel banjo hard lines for a Baer Remaster master cylinder feeding a Remaster proportioning valve. The lines are made for 15/16 inch and 1 inch bores and fit left and right port configurations, and the banjo styling suits show car builds.
The banjo ends give the run a clean, streamlined appearance. The kit includes four banjo bolts and eight copper crush washers, which seal each banjo connection. The lines are specific to Remaster bore size, so check your cylinder before assembly. No vehicle years, makes or models are named for this part.
Key features
- Stainless steel construction with a brilliant chrome finish
- Banjo fittings for a clean, streamlined look
- Fits 15/16 inch and 1 inch Remaster bore sizes
- Works with left and right port configurations
- Includes two hard lines, four banjo bolts and eight washers
- Pre-formed lines with mounting hardware included
Care and crush washer replacement
Banjo joints depend on the crush washers to seal, and a washer that has been compressed once does not reliably reseal. Each time a banjo bolt is loosened, fit new washers and tighten the bolt evenly so the washer seats flat against the banjo face.
Because the banjo bolts pass fluid through a hollow center, a worn or cracked banjo face can leak even when the bolt is tight. Inspect the faces for scoring during assembly. Polished and chrome finishes show fingerprints and light scratches, so handle the lines with clean gloves and store them wrapped until installation.
- Replace crush washers whenever a banjo joint is opened
- Inspect banjo faces for scoring before assembly
- Recheck banjo bolts after the first drives
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801311 |
| UPC | 844165052241 |
| Series | ReMaster |
| Color | Polished |
| Finish | Brilliant chrome |
| Line material | Stainless steel |
| Included | 2 hard lines, 4 banjo bolts, 8 washers |
| Banjo bolt quantity | 4 |
| Crush washers included | Yes |
| End 1 fitting gender | Female |
| End 2 fitting gender | Female |
| End 2 fitting type | Banjo |
| Pre-formed | Yes |
| Mounting hardware included | Yes |
| Fittings included | Yes |
| Quantity | Kit |
| Grade | Premium |
| DOT approved | No |
| Connector for warning light | No |
| Emission code | 6 |
| Country of origin | USA |
Vehicle fitment
The kit is matched to Remaster master cylinders in 15/16 inch and 1 inch bores and to a Remaster proportioning valve, not to named vehicles. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replace the crush washers whenever a banjo joint is opened, because each washer seals only once it is compressed. Check the route for clearance against the cylinder and valve before final tightening, since the lines are pre-formed. Once assembled, bleed the brakes and look for leaks at every banjo joint.
What’s included
Two hard lines, four banjo bolts and eight copper crush washers, plus mounting hardware.
Not included: the master cylinder and proportioning valve, which are separate parts.












