Overview
The Baer Brakes 6801312 is a set of two stainless steel inverted flare hard lines that connect a Remaster master cylinder to a Remaster-specific proportioning valve. They fit 15/16 inch or 1 inch bore Remaster master cylinders and work with both left and right port configurations.
Both ends use a 3/16 inch inverted flare fitting with a tube nut and brass seat, and the proportioning outlet port is 3/8-24 inch. The lines are pre-formed rigid tubing rather than flexible hose, which keeps the run between the cylinder and valve fixed in place. Baer notes they are specific to Remaster bore size, so confirm your cylinder’s bore first. The set comes as a pair with four tube nuts, and no specific vehicles are named for this part.
Key features
- Stainless steel line construction
- Designed to connect a Baer Remaster proportioning valve to a Remaster master cylinder
- Fits 15/16 inch and 1 inch bore Remaster master cylinders
- Works on left and right port Remaster configurations
- Inverted flare fittings with brass seats on both ends
- Pre-formed lines with mounting hardware included
Routing and clearance
Hard lines are fixed in place, so their route matters as much as their fittings. Rigid tubing does not flex with suspension travel or engine movement, which means each bend has to clear the frame, steering parts, exhaust heat and moving components. Before final tightening, compare the new route with the old line and confirm there is clearance at every point along the run.
When choosing a line set, start with the master cylinder bore and the valve outlet thread, since a near match can still fail to seal. Clean tube nut and seat faces before assembly, and check the flare for scratches or burrs. Once the lines are installed, bleed the system in the correct order and check each joint for seepage under pressure.
- Inspect lines for surface rust, dents, kinks and chafing at every brake service
- Replace crush washers and seals whenever a fitting is loosened
- Use a flare wrench on tube nuts to avoid rounding the corners
- Tighten joints evenly and recheck them after the first drive
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801312 |
| UPC | 844165052258 |
| Series | ReMaster |
| Color | Silver |
| Line material | Stainless steel |
| Quantity | Kit of two hard lines |
| Included | 2 hard lines, 4 tube nuts |
| Inlet and outlet fittings | 3/16 inch inverted flare and tube nuts with brass seat |
| End thread diameter | 3/8 inch (.375) |
| Flare type | Inverted, both ends |
| Fitting gender | Male, both ends |
| Proportioning outlet port size | 3/8-24 inch |
| Pre-formed | Yes |
| Mounting hardware included | Yes |
| Crush washers included | No |
| DOT approved | No |
| Connector for warning light | No |
| Grade | Premium |
| Country of origin | USA |
Vehicle fitment
The kit is matched to Remaster master cylinders in 15/16 inch and 1 inch bores rather than to named vehicles. Confirm your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Match the bore first, since the lines are specific to Remaster bore size. Because they are pre-formed, hold each line against the cylinder and valve to check the route before final tightening. Brake lines carry fluid under pressure, so bleed the system and inspect each joint once the work is done.
What’s included
The kit has two stainless steel hard lines and four tube nuts, along with mounting hardware.
Not included: crush washers.










