Overview
The Baer Brakes 6800502 is a 23-inch braided brake hose set with a 3AN female straight end and a 10 mm banjo end at 20 degrees. The set is packaged as two hoses and attaches directly to an OE hard brake line.
Baer describes these hoses as designed for high-performance braking. The steel braided stainless construction is paired with a Teflon liner that Baer says prevents expansion for a more consistent pedal feel, and the hoses are DOT approved. Baer positions the set for maintaining, upgrading or customizing a brake system.
Key features
- Steel braided construction with stainless steel hose material.
- Teflon liner to prevent expansion for a consistent pedal feel.
- DOT approved.
- Attaches directly to an OE hard line; neither hose is bracket attached.
- Packaged as a pair, two hoses per set.
- End 1: -3 AN fitting, 3AN female straight, 3/8-24 inch UNJF thread.
- End 2: banjo fitting at 20 degrees with a 10 mm banjo bolt hex.
- 23-inch hose length.
Choosing the right setup
Braided hoses replace the rubber flexible section of a brake line, so the hose has to match the fitting type at each end before anything else. Check the end fittings, the banjo connection and the hose length against the OE line before buying, because a hose that is too short will stretch under suspension travel and a hose that is too long can rub or kink. Steel braiding resists abrasion better than rubber, but it still needs clear routing away from heat and moving parts.
Hoses like these are often replaced together with new crush washers and fresh brake fluid, since opening the system is a good time to address both. Inspect the existing rubber hoses for cracking, bulging or seepage at the fittings. Any soft pedal, visible fluid or swelling is a sign the old part should come off.
- Confirm the banjo angle matches the caliper before tightening
- Route the hose clear of tires, exhaust heat and suspension links
- Replace crush washers on every banjo connection you open
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6800502 |
| UPC | 90127990650 |
| Hose length | 23 inches |
| End 1 fitting | -3 AN, 3AN female straight |
| End 1 thread | 3/8-24 inch UNJF |
| End 2 fitting | Banjo, 20 degrees |
| Banjo bolt hex size | 10 mm |
| Hose material | Stainless steel, steel braided |
| Fitting material | Steel |
| Grade type | Performance |
| Pack format | Set of two hoses, packaged as a pair |
| Crush washers included | No |
| Bracket attached | No, neither hose |
| Emission code | 6 |
| Country of origin | USA |
Vehicle fitment
Because no vehicle is named, the thread size and banjo end should not be matched to a vehicle by eye. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Each hose attaches directly to an OE hard line, and neither hose is bracket attached, so mounting depends on the existing line connection. Crush washers are not included, so have new ones on hand for the banjo connections. Because this is a brake line, bleed the system and test the pedal before driving.
What’s included
The set contains two braided brake hoses, packaged as a pair.
Not included: crush washers.














