Overview
The Baer Brakes 6801313 is a silver, stainless steel inverted flare hard line that connects a Baer ReMaster master cylinder to the Baer general fit proportioning valve, part number 2000035. This brake line, also called a brake hard line or brake tube, carries fluid between the two components and is built to locate the proportioning valve under the ReMaster.
The line is sold as one each with two 3/16 inch inverted flare tube nuts with brass seats and mounting hardware. It works on both left and right port ReMaster master cylinders and fits 15/16 inch and 1 inch bore units. It is part of the Baer ReMaster series and is not DOT approved.
Key features
- Designed to connect the Baer general fit proportioning valve to a Baer ReMaster master cylinder
- Fits 15/16 inch and 1 inch ReMaster bore master cylinders
- Works on left and right port ReMaster master cylinders
- Inverted flare fittings with 3/16 inch inverted flare tube nuts and brass seats
- Positions the proportioning valve under the ReMaster
- Pre-formed stainless steel line in a silver finish
Choosing a proportioning valve
A proportioning valve controls how much pressure reaches the rear brakes compared with the front, so its position and plumbing directly affect braking balance. When a valve is relocated, the line feeding it has to reach without kinking or rubbing. A general fit valve gives more mounting options, but the chosen spot should keep the lines short and protected from heat and debris.
Because the line connects two fixed components, check the bend geometry before final tightening. Route it away from moving parts and sharp edges, and make sure the valve body has room for the tube nut to seat square.
Brake system parts are usually replaced in sets. If the valve or master cylinder is being changed, plan on new seals, a proper bleed, and a careful test of pedal feel before regular driving.
- Match the valve type to the master cylinder setup
- Keep lines clear of heat, debris, and moving parts
- Bleed the system after any line work
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801313 |
| UPC | 844165052265 |
| Series | ReMaster |
| Color | Silver |
| Line material | Stainless steel |
| Pre-formed | Yes |
| End 1 fitting | Male compression, inverted flare |
| End 1 thread diameter | 3/8, .375 |
| End 2 fitting | Male compression, inverted flare |
| End 2 thread diameter | .375, 3/8 |
| Inlet and outlet fittings | 3/16 inch inverted flare and tube nuts with brass seat |
| Proportioning outlet port size | 3/8-24 inch |
| Fittings included | Yes |
| Mounting hardware included | Yes |
| Crush washers included | No |
| DOT approved | No |
| Connector for warning light | No |
| Grade | Premium |
| Sold as | Each |
| Box count | 1 |
| Country of origin | USA |
Vehicle fitment
The line is matched by master cylinder bore and proportioning valve rather than by vehicle. It is designed for Baer ReMaster master cylinders with 15/16 inch or 1 inch bores and for the Baer general fit proportioning valve, part number 2000035.
Installation notes
The line is pre-formed and comes with mounting hardware, which is meant to position the proportioning valve under the ReMaster. Brake line work should be done by a qualified installer, and the brake system should be checked for leaks before driving.
What’s included
One stainless steel hard line, two tube nuts and mounting hardware, with fittings included.
Not included: The Baer ReMaster master cylinder and the Baer general fit proportioning valve, part number 2000035, are needed to complete this setup.











