Overview
The Artec HP Dana 30 Front Axle Truss, XJ3001, is a steel truss that reinforces a high pinion Dana 30 front axle. The 1/4-inch thick truss top and 10Ga. gusseting strengthen both axle tubes, not only the long tube.
This is truss only. Bushings, joints and keyed tabs are not included and must be sourced separately. The precision cut and formed components make installation straightforward, though the job calls for general welding and fabrication skills.
Key features
- 1/4-inch mild steel truss top
- 10Ga. gusseting strengthens both axle tubes
- Spans the length of the long and short side of the axle
- Precision cut and formed components
- Supplied as bare steel
- Heavy duty, light weight truss system
Before you weld
A front truss works by tying the axle tubes together so that the housing resists twisting under load. Because the top and gussets take most of that load, the weld joints need to be complete and square. Clamp the truss to the axle, check its position on both tubes, and only then start welding. Work in stages so heat does not pull the housing out of alignment.
Bare steel will start to rust quickly if left exposed, so consider a paint or coating after fabrication is finished. Check the axle carefully after the first trail sessions for cracked welds or loose hardware, and recheck the truss after any major repair to the front end.
- Dry fit before final welding
- Stage welds to limit heat distortion
- Inspect welds after early trail use
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | XJ3001 |
| UPC | 816791024886 |
| Axle type | Dana 30, high pinion |
| Axle location | Front axle |
| Truss material | 1/4-inch mild steel |
| Gusseting | 10Ga. |
| Finish | Bare steel |
| Steering ram mount | Without steering ram mount |
| Included | Truss only |
| Fitment | Direct fit |
Vehicle fitment
It is made for a front high pinion Dana 30 axle, such as the Dana 30 XJ axle. Confirm your axle type before installing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Keyhole slots on top of the truss, where keyed tabs would go, must be filled with weld. Do not use this truss if the passenger side upper control arm is connected.
What’s included
Truss only. Bushings, joints and keyed tabs are not included.
Not included: Bushings, joints and keyed tabs.









