Overview
The Artec coilover tabs for truss, part number TB1010, are mounting tabs that let you attach shocks or coilovers near the ends of an axle. They are intended for Artec’s rear Dana 60 truss, which reinforces the entire axle against bending or breaking.
Each tab is CNC cut from 1/4 inch thick mild steel and includes a 1/2 inch hole common to most shocks. Tabs are meant to be mounted 1.25 inches apart. Four pieces are included for use with two shocks.
Key features
- CNC cut from 1/4 inch thick mild steel
- 1/2 inch hole common to most shocks
- Intended to be mounted 1.25 inches apart
- Four pieces for two shocks
- No steering ram mount
Shock mounts on a truss
Shock mounts on an axle truss carry the damping load where the shock meets the axle, so the placement determines how the shock works through its stroke. Set the shock angle so it does not bind at full droop or full compression. Keep the shock clear of the tire, brake lines and any brackets on the axle.
Coilover setups add spring load to the mount, so check the mount welds and the truss area after the first few trips. Shock eyes and bushings wear with use, and a worn eye can make the shock knock. When replacing shocks, check the bushings and hardware at the same time, since both carry the load.
- Check shock clearance at full lock
- Inspect welds after hard use
- Replace worn shock bushings with the shocks
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | TB1010 |
| UPC | 816791023599 |
| Material | Mild steel |
| Thickness | 1/4 inch |
| Hole | 1/2 inch |
| Mounting spacing | 1.25 inches |
| Pieces | 4 |
| Axle type | Universal |
| Axle location | Rear |
| Steering ram mount | Without |
Vehicle fitment
No vehicle is named. The tabs are tied to Artec’s rear Dana 60 truss, and the fitment field reads universal fit, so the match depends on your rear axle and truss rather than a vehicle model.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Shocks mount through the 1/2 inch hole, with the tabs set 1.25 inches apart. Select welding or bolt-on hardware that suits your truss and check the fit before final tightening.
What’s included
Four tab pieces, enough for two shocks.
Not included: shocks, coilovers and mounting hardware.









