Overview
The Artec Industries JK3001 is a front axle truss for the Dana 30 front axle on Jeep Wrangler JK models, covering the 2007 to 2018 Wrangler (JK) with 2-door and 4-door bodies. It is a truss top and gusset system with armor that reinforces the front axle against heavy use.
The truss top is 1/4 inch thick and the gussets are 10 gauge. Its design strengthens both axle tubes rather than only the long tube. The axle tubes are a known weak area, and the truss reinforces that area.
The components are precision cut and formed to make installation straightforward. The kit still needs general welding and fabrication skills, including welding to the cast center section of the axle.
Key features
- Truss top and gussets reinforce both front axle tubes
- 1/4 inch thick truss top
- 10 gauge gussets
- Precision cut and formed components
- Designed for the Dana 30 front axle on JK models
Preparing the front axle for welding
A truss is only as good as the welds that hold it, so fit-up matters. Dry fit every piece, check that the gussets sit flat against both tubes, and confirm the truss top lines up with the center section before striking an arc. Clean paint, rust and grease from the contact areas so the weld can fuse properly.
Front axle work also affects steering and driveline geometry. After a truss is welded in, check track width, pinion angle and tire clearance through full steering lock. Trusses are often installed alongside other axle and steering upgrades, so plan the order of work to avoid rework.
- Dry fit all parts before welding
- Grind contact surfaces clean
- Check tire clearance at full lock
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | JK3001 |
| UPC | 816791021656 |
| Axle | Dana 30 front axle |
| Body style | 2-door and 4-door models |
| Truss top | 1/4 inch steel |
| Gussets | 10 gauge steel |
| Fitment type | Direct fit |
| Steering ram mount | Without steering ram mount |
Vehicle fitment
It is made for the front Dana 30 axle on JK Wranglers, the 2007 to 2018 Jeep Wrangler (JK). Other Wrangler generations, such as the TJ or JL, and other axles are outside this kit’s application.
Artec has not tested this truss on non-US JK models with diesel engines or on right-hand drive axles. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Artec intends this kit for vehicles with at least minor lifts. If you install it on a vehicle with no lift, check clearances before welding anything in place.
What’s included
The truss top and gussets described above, cut and formed for the Dana 30 front axle.
Not included: a steering ram mount. This kit is listed without one.








