Overview
The 4 Wheel Parts 4WP Factory tubular front upper control arm, part number 4WP57006B, is a front upper arm with a high angle ball joint for 2005–2023 Toyota Tacoma models.
The arm pairs the strength of a race-style uniball arm with the ride of a factory part, using a high angle ball joint. It offers increased strength and corrects alignment after a lift, with an on-road ride close to OE and without the noise of traditional uniball arms.
The arm uses low maintenance PTMEG bushings, helix grooved pivot points and a sealed dust cap. 4 Wheel Parts says these features give years of quiet performance from the arm’s pivots.
Key features
- Tubular construction
- High angle ball joint, which 4 Wheel Parts says gives a factory-like ride
- Low maintenance PTMEG bushings
- Helix grooved pivot points
- Sealed dust cap for the pivots
- Corrects alignment after a lift.
Before you align
Upper control arms locate the axle and carry the upper ball joint, so their condition affects steering feel, tire wear and alignment. Worn ball joints often show up as clunks over bumps or play when the wheel is rocked, and a bent arm can cause uneven tire wear on one side. Inspect the boots, pivot points and mounting bolts whenever the suspension is apart.
Arms are often replaced in pairs so both sides wear and handle the same way. Because a new arm changes caster and camber, plan for an alignment visit once installation is complete. Re-check the mounting bolts after the first few drives and again after the first alignment.
- Check the ball joint for play before installation
- Inspect the lower arms and tie rod ends at the same time
- Replace worn pivot bushings along with the arm when they are not included
Specifications
| Brand | 4 Wheel Parts |
|---|---|
| Part number | 4WP57006B |
| Position | Front upper |
| Construction | Tube |
| Joint design | Ball joint (high angle) |
| Bushings | PTMEG |
| Pivot points | Helix grooved |
| Dust protection | Sealed dust cap |
| Fitment | Direct fit for 2005-2023 Toyota Tacoma. |
Vehicle fitment
The arm fits 2005–2023 Toyota Tacoma models across the trim levels in that window, covering the full run of Tacoma model years in that span.
The list names only the Tacoma, so Toyota Tundra and 4Runner models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The arm can correct alignment after a lift, but have the vehicle aligned after installing new upper arms.
What’s included
One front upper control arm of tube construction with a ball joint. Check the package contents against your installation before starting.








