Overview
The TeraFlex 3442002 is a set of four ball joints for the front axles of the Jeep Wrangler JK: two uppers and two lowers, for both sides. The joints are built for Dana 30 and Dana 44 axles and are the non-knurled version. Non-knurled joints do not score the inner knuckle or open up the bore, and knurled joints suit loose press fits after repeated replacements. The joints fit 2007–2011 JK axles.
TeraFlex builds the uppers with sintered wear bushings to resist side loads from heavier tires and offset wheels. The lowers have a threaded top cap for preload and a grease passage, which lets the joint be serviced without removing the axle shaft. The ball and stud are 4140 chrome moly, and the housing is 1045 carbon steel with a magnesium phosphate finish.
Key features
- Four-joint set: two upper and two lower
- Without knurl, for tight knuckle bores
- Sintered upper bushing and high carbon spring
- 4140 chrome moly ball and stud with anti-corrosion coating
- Black neoprene boot and factory-style serrated flanged castle nut
Set replacement on one vehicle
A four-joint set replaces the full front ball joint arrangement on one vehicle, covering both sides at the upper and lower positions. Replacing all four keeps the joints at similar wear levels and avoids a mismatch that can affect steering feel. The sintered upper bushings and the threaded lower top cap are designed for the load each joint carries in its position.
Before starting, make sure the front axle is the correct type and that the knuckles are in good condition. Support the axle properly, and never work under a vehicle held up only by a jack. Once installed, check the steering for play, look at the boots for correct seating, and inspect the control arms and tie rod ends while the front end is apart.
- Replace all four joints together
- Inspect control arms and tie rod ends during install
- Recheck torque on castle nuts after the first drive
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 3442002 |
| UPC | 843885031598 |
| Set contents | Two upper and two lower joints |
| Knurl | Without knurl |
| Upper bushing | Sintered |
| Ball and stud | 4140 chrome moly |
| Housing | 1045 carbon steel, magnesium phosphate coated |
| Boot | Black neoprene |
Vehicle fitment
It fits 2007–2015 Jeep Wrangler (JK) models, including Rubicon, Sahara and Unlimited versions. The joints themselves fit 2007–2011 JK Wrangler Dana 30 and Dana 44 axles. Confirm your front axle is a Dana 30 or Dana 44 before ordering.
Wrangler TJ, LJ and JL models are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Two upper and two lower ball joints, without knurl, with boots and castle nuts. Each side gets one upper and one lower joint, so the set covers the full front end of one vehicle.









