Overview
The SPOD Bantam BAN8-700-TSB-36 is an 8-circuit control system with a touchscreen, supplied with 36-inch battery cables. It switches and powers 12/24VDC auxiliary accessories from one central unit. It is universal fit, so it is not built around a particular year, make or model of vehicle.
The Bantam is a small, expandable system that connects to the cab through a single ethernet cable. Accessories are wired to the unit rather than run through the cab, which avoids cutting into the cab, fishing wires through it or tapping the vehicle’s electrical system. The compact unit can be placed in many locations and suits anyone adding several electrical accessories who wants one control point.
Key features
- 8 circuits, expandable, for 12/24VDC accessories
- One ethernet cable connects the control panel to the unit in the cab
- Protection against over current, over heat, short circuit and reverse polarity
- Field collapse protection
- Low voltage detection shuts the system and all attached accessories off when battery voltage drops below 11.2VDC
- 16-position terminal block for ground and power connections to the accessories
- 8-position input terminal block for controlling outputs, accepting 3.3VDC to 24VDC inputs
- Removable dust cover with spots for legends and port identifications
Planning the wiring
Good layout makes an accessory system easier to troubleshoot later. Sort accessories by current draw and by how often they are used, then assign the output and terminal positions before cutting any wire. Keep the control inputs apart from the power outputs so switching noise and wiring errors are easier to trace.
A single ethernet cable carries control into the cab, so its route matters as much as the unit’s location. Keep the cable clear of pedals, steering components and anything that heats up. Where the cable passes through existing openings, use the same grommets or protective sleeves so the path stays sealed against dust and water.
- Sort accessories by current draw
- Keep power and control wiring separate
- Secure the ethernet cable at regular intervals
- Label both ends of each accessory wire
Specifications
| Brand | SPOD |
|---|---|
| Part number | BAN8-700-TSB-36 |
| UPC | 700008545921 |
| Circuits | 8, expandable |
| Accessory voltage | 12/24VDC |
| Control input range | 3.3VDC to 24VDC |
| Low voltage cutoff | 11.2VDC battery voltage |
| Battery cables | 36-inch |
| Touchscreen | Included |
| Terminal blocks | 16-position power and ground; 8-position control inputs |
Vehicle fitment
The Bantam is universal fit and is not a vehicle-specific part, so no year, make or model applies. Check that the 36-inch battery cables reach the battery from the mounting spot before ordering.
Installation notes
SPOD’s description says installation needs no cutting into the cab and no tapping into the vehicle’s electrical system. Wire the accessories to the 16-position block and the control inputs to the 8-position block, then route the single ethernet cable to the cab. Disconnect the battery before you connect the battery cables.
What’s included
The kit is the Bantam control unit with touchscreen and 36-inch battery cables.
Not included: the 12/24VDC accessories you connect to the outputs, and the switches or wiring they need.









