Overview
This is the HD version of the 8-circuit Bantam control system, supplied with 36-inch battery cables. It controls and powers 12/24VDC auxiliary accessories from a single unit, and it is universal fit, so it does not depend on a particular year, make or model.
One ethernet cable links the unit to the cab. That means no cutting into the cab, no fishing wires through it and no tapping into the vehicle’s electrical system. The unit is small enough to fit in many mounting positions, and the HD build keeps the same 8-circuit design with the 36-inch battery cable length.
Key features
- 8 expandable circuits for 12/24VDC accessories
- Single ethernet cable into the cab for control
- Protection against over current, over heat, short circuit and reverse polarity
- Field collapse protection
- Low voltage detection turns the system off when battery voltage drops below 11.2VDC
- 16-position terminal block for ground and power
- 8-position input block for controlling outputs, with 3.3VDC to 24VDC inputs
- Removable dust cover with spots for legends and port identifications
Mounting and routing
Mounting a compact control unit is mostly about access and protection. Choose a spot that keeps the terminal blocks reachable without pulling on the wires, and that stays dry and away from direct heat. The 36-inch battery cables need a clear path to the battery, so check that the route is free of sharp edges before fixing the unit in place.
The HD build is intended for demanding use, so the wiring should be planned to match. Use strain relief where cables leave the unit, and avoid tight bends near the connectors. Keep grounds short and clean, and make sure the battery connection is secure, since loose power connections are a common cause of intermittent faults.
- Keep the unit off direct heat and wet surfaces
- Add strain relief at each cable exit
- Use clean bare metal for grounds
- Recheck battery connections after rough trails
Specifications
| Brand | SPOD |
|---|---|
| Part number | BAN8-800-HD-36 |
| UPC | 816482021385 |
| Version | HD |
| Circuits | 8, expandable |
| Accessory voltage | 12/24VDC |
| Control input range | 3.3VDC to 24VDC |
| Low voltage cutoff | 11.2VDC battery voltage |
| Battery cables | 36-inch |
| Terminal blocks | 16-position power and ground; 8-position control inputs |
Vehicle fitment
It is universal fit, so no vehicle year, make or model applies. Check that the 36-inch battery cables reach the battery from your chosen mounting spot.
Installation notes
The Bantam is wired through its two terminal blocks: accessories to the 16-position block and control inputs to the 8-position block. Route the single ethernet cable to the cab. Disconnect the battery before connecting the battery cables.
What’s included
The kit is the HD Bantam control unit with 36-inch battery cables.
Not included: the 12/24VDC accessories connected to the outputs, along with their switches and wiring.









