Overview
The SPOD JK Wrangler 8 Circuit SE Special Edition System with Amber LEDs, part 8-600-0915-LEDA, is a programmable eight-circuit switch system for the 2009 to 2016 Jeep Wrangler JK. It covers the Rubicon, Sahara, Sport and Unlimited versions in 2-door and 4-door models, and it uses a panel with amber indicator lights.
The control unit is the SourceSE, a fully programmable digital module controlled over CAN-Bus with a maximum capacity of 100 amps. It is engineered and manufactured in the United States. Each of the eight switches controls one circuit rated at 30 amps at 12.5 VDC, and the circuits can be daisy chained, selectable in the set-up, to reach up to 32 circuits.
Key features
- Eight switches with amber LED indicator lights
- Expandable to up to 32 circuits with plug-and-play connections
- Low-voltage cutoff with a specified cutoff of 11.2 VDC
- Two-minute delay before the SourceSE shuts down on low voltage
- Current-sensing MOSFETs in place of fuses on accessory outputs, protecting from 1.5 to 30 amps automatically
- Self-healing fault protection under microprocessor control
- Switches 1 and 2 can run from ignition power or high-beam circuits
- Each switch can be programmed for strobe or flash
- Automatic shutdown when the panel is unplugged
Programming and expansion planning
A programmable switch system rewards a little planning before the wiring starts. Decide which accessories will sit on which switches, and note which circuits need to stay on with the ignition off. Switches 1 and 2 have ignition and high-beam options, so give those two switches the accessories that suit those modes.
Expansion is easier when the first install leaves room for more modules. Keep the Ethernet cable run tidy and avoid pinching it, and plan the power feed for every module you may add later. Protection on each output is handled electronically, so a clear plan on the load side matters more than fuse selection.
- Map each switch to its accessory before wiring
- Plan switches 1 and 2 for ignition or high-beam use
- Leave room in the panel layout for expansion
Specifications
| Brand | SPOD |
|---|---|
| Part number | 8-600-0915-LEDA |
| UPC | 700007270461 |
| Switches | 8, amber LED indicators |
| Circuit rating | 30 amps at 12.5 VDC each |
| Maximum capacity | 100 amps |
| Protection range | 1.5 to 30 amps |
| Low-voltage cutoff | 11.2 VDC, two-minute delay |
| Panel cable | RJ-45 Ethernet, 10 feet standard |
Vehicle fitment
It fits the 2009 to 2016 Jeep Wrangler (JK), including the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X versions, and the Unlimited versions of each, in 2-door and 4-door models.
Its coverage is limited to 2009 to 2016 JK models, so TJ and LJ Wrangler models are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Connect the panel to the SourceSE with the RJ-45 Ethernet cable, which is 10 feet as standard. Switches 1 and 2 can be set to ignition power with a DIP switch setting and a jumper wire tapped into a fuse that is live only when the ignition is on. The LVCO protection and reset use one ATM mini-style fuse.
What’s included
The kit includes the eight-switch amber panel, the SourceSE module, the 10-foot Ethernet cable and the OEM vehicle-specific installation hardware. The optional Bluetooth module is a separate purchase.

















