Overview
The SPOD 8-600-0915-LEDR is a programmable switch system with eight circuits and red indicator lights, for the 2009 to 2016 Jeep Wrangler JK. It covers the Rubicon, Sahara, Sport and Unlimited versions in 2-door and 4-door bodies.
The SourceSE is a digital, CAN-Bus controlled power module with a maximum capacity of 100 amps. Each switch runs one circuit rated at 30 amps at 12.5 VDC. The module is engineered and manufactured in the United States, and it can be expanded to 32 circuits by daisy chaining modules through its selectable set-up.
Key features
- Eight switches with red LED indicator lights
- Expandable to up to 32 circuits
- Low-voltage cutoff with a specified cutoff of 11.2 VDC
- Two-minute delay before the SourceSE shuts down on low voltage
- Current-sensing MOSFETs replace accessory fuses and protect from 1.5 to 30 amps automatically
- Self-healing fault protection under microprocessor control
- Ignition-switched or high-beam operation on switches 1 and 2
- Programmable for strobe or flash on each switch
- Automatic shutdown when the switch panel is unplugged
Daily use of a red-lit panel
Indicator lights do most of their work at night, when a clear red glow shows which circuit is active without glaring at the driver. Red is often easier on night vision than white, which can matter on dark trails. Check that each light responds when its switch is pressed, since a dead indicator usually points to a wiring or connection issue.
The panel is one part of a larger system, so daily use also depends on the relays, the module and the battery state. Shut off accessories you do not need before parking, and keep the Ethernet connection firm. A simple routine of checking lights and connections keeps the system dependable over time.
- Test each indicator after installation
- Check the Ethernet plug after rough trails
- Turn off unused circuits before parking
Specifications
| Brand | SPOD |
|---|---|
| Part number | 8-600-0915-LEDR |
| UPC | 700007270481 |
| Switches | 8, red LED indicators |
| Circuit rating | 30 amps at 12.5 VDC each |
| Maximum capacity | 100 amps |
| Protection range | 1.5 to 30 amps |
| Low-voltage cutoff | 11.2 VDC, two-minute delay |
| Panel cable | RJ-45 Ethernet, 10 feet standard |
Vehicle fitment
It fits the 2009 to 2016 Jeep Wrangler (JK), with 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X versions, and the Unlimited versions of each, in 2-door and 4-door models.
Its coverage is limited to 2009 to 2016 JK models, so TJ and LJ Wrangler models are not part of this fitment. Compare your vehicle’s year, model and trim with this range before ordering.
Installation notes
The panel plugs into the SourceSE with an RJ-45 cable on each end, and the standard length is 10 feet. For switches 1 and 2 on ignition power, change the DIP switch setting and run a jumper wire to a fuse that is only live with the ignition on. The low-voltage protection can be turned off with the DIP switches.
What’s included
The kit includes the eight-switch red panel, the SourceSE module, the 10-foot Ethernet cable and OEM vehicle-specific installation hardware. The optional Bluetooth module is not included.

















