Overview
The SPOD 6 Switch System and Source System with Blue Switches, part number 600-0915LT-LEDB, is a fused and relayed power distribution block with six switches for adding accessories to a 2009-2017 Jeep Wrangler JK. Fitment here is based on the product title, which names the 2009 – 2017 JK model.
The sPOD with Source System is a complete, fully integrated power distribution block that works plug and play. Its integrated low-voltage cut-off (LVCO) monitors battery voltage and switches off each accessory when the battery falls below operating voltage, so the vehicle keeps enough voltage to start.
Key features
- Complete, fully integrated power distribution block
- Plug and play, pre-wired and ready to install
- Fused and relayed for adding accessories
- Integrated LVCO cuts off each accessory when battery voltage drops
- Blue switches in a 6 switch system
Keeping the battery healthy
Any accessory system draws from the battery, and a low-voltage cut-off is one way to protect the starting capacity of the vehicle. The cut-off is useful when lights, compressors or other loads run with the engine off, since a drained battery can leave you stranded at a campsite. It does not replace good battery care, so keep terminals clean and check the battery condition periodically.
Battery health matters most in cold weather and after long periods of inactivity. If the battery is aging, load test it before adding more accessories, since a weak battery reaches the cut-off point sooner. Use a battery maintainer when the vehicle sits for extended periods, and recheck the switch wiring after any battery replacement.
- Clean and tighten battery terminals
- Load test an aging battery
- Use a maintainer during long storage
Specifications
| Brand | SPOD |
|---|---|
| Part number | 600-0915LT-LEDB |
| UPC | 700007270121 |
| Switch system | 6 switch |
| Switch color | Blue |
| Low-voltage protection | Integrated LVCO |
| Supply | Pre-wired, ready to install |
Vehicle fitment
Fitment is based on the product title, which names the 2009 – 2017 JK model, so this system is for the 2009-2017 Jeep Wrangler JK. Confirm your vehicle’s year, model and trim before ordering.
The Wrangler JL and Gladiator JT generations are not covered by this range. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The system is supplied pre-wired, so installation centers on connecting the battery and the accessory circuits to the block. Keep the battery disconnected until the accessory wiring is complete.
What’s included
The complete sPOD with Source System, pre-wired and ready to install, with the six switch system. Accessories you add to the circuits are not included.


















