Overview
The RE1469 is an 8 degree steel shim for 2.5 inch wide leaf springs, sold as a pair. It sets pinion angle at the front or rear axle and is a universal design.
The shim is made from solid steel and sits inside the spring pack rather than floating between the pack and the spring perch, so it stays put once the pack is assembled. That placement keeps the center pin fully engaged. Center pins are not included.
Key features
- 8 degree angle
- Solid steel construction
- Designed for 2.5 in wide springs
- Becomes part of the spring pack rather than floating
- Usable at the front or rear
Setting pinion angle with shims
Pinion angle controls how the driveshaft meets the differential. When the angle is off, the joints work harder and the driveline can vibrate, especially at highway speed. Leaf spring shims are one way to correct it, and they change the angle by tilting the axle housing relative to the frame. Because each shim is a fixed angle, the job is about matching the correction to the measured error rather than guessing.
Before installing, look over the spring pack, center bolts and U-bolts for wear or cracked leaves. A shim should seat flat against the spring. If a pack has worn or sagging leaves, the shim alone will not restore the original geometry. Recheck the driveline angles after any change in tire size or suspension height, since those shift pinion angle too.
- Inspect U-bolts and spring hangers before fitting
- Check driveshaft U-joints for wear after adjustment
- Recheck pinion angle after tire or lift changes
- Keep shim pairs together and labeled by side
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1469 |
| UPC | 614901438406 |
| Angle | 8 degree |
| Spring width | 2.5 in wide springs only |
| Material | Steel |
| Quantity | Sold as a pair |
| Center pins | Not included |
| Design | Universal |
Vehicle fitment
The shim is a universal design sized for 2.5 inch wide springs. Check your spring width and the pinion angle you need before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Center pins are not included, so you need them before installing the shims. Because the shim changes pinion angle, measure the pinion angle again after installation and adjust as needed. Once the spring pack is assembled, the shim stays in place.
What’s included
A pair of 8 degree steel shims.
Not included: center pins.



