Overview
The Rancho RS8125 is a pair of leaf spring shims, each 2.5 inches wide with a 2 degree angle. Leaf spring shims are placed between a leaf spring and its mounting surface to change the angle of the axle. The RS8125 kit is listed without center pins, so any center pin hardware must be sourced separately.
The kit is universal fit, so it is not tied to a specific year, make or model. Check that the 2 degree angle suits your leaf spring setup before installing.
Setting the spring angle
A shim changes the angle between the leaf spring and its mounting surface, which shifts the axle’s pinion angle relative to the driveline. Small angle changes can smooth out vibration, but too much angle can strain U-joints and cause driveline buzz at highway speeds. Plan the angle around your ride height and any other lift components already installed.
Shims are usually installed with the spring unloaded, and the U-bolts often need to be re-torqued after the first drive. Check the length of the U-bolts and clearance to brake lines and the fuel tank before installing. Center pins, if you buy them separately, should match the spring’s hole size and be checked for wear before reuse.
- Measure pinion and transmission angles before and after installing
- Check U-bolt length and thread engagement
- Inspect the center pin holes for elongation
- Recheck clamp torque after the first few miles
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS8125 |
| UPC | 39703812504 |
| Width | 2.5 inches |
| Angle | 2 degree |
| Center pins | Without center pins |
| Fitment | Universal fit |
Vehicle fitment
Universal fit does not tie the kit to a spring, axle or truck. Confirm the shims suit your leaf spring and axle setup before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
A pair of leaf spring shims, each 2.5 inches wide.
Not included: Center pins.






