Overview
The Warrior 800051 is a pair of 4 degree leaf spring axle shims, 2″ wide, made in the USA from steel, for correcting the pinion and caster angles on a leaf sprung Jeep or truck.
Warrior says its heavy-duty shims are designed to be permanently attached to the leaf spring pack using the leaf’s cross-pin. The cross holes are counter-bored against the angled surface so the cross-pin gets even clamping force across the top of the pin, and the steel construction keeps the shims from breaking under heavy load.
Together these features, Warrior says, create a shim that resists spinning out of place, falling out or breaking. This 4 degree size is the version without center pins.
Pinion angle matters on a lifted vehicle because the driveshaft needs the axle yoke pointed toward the transfer case or transmission output. A shim of the right degree rotates the axle to restore that angle, and the same idea applies to caster at the front axle.
Key features
- 4 degree leaf spring axle shim
- 2″ wide
- American-made from high quality steel
- Counter-bored cross hole for even clamping force on the cross-pin
- Accepts a 5/16″ cross-pin
- Easily drilled to fit larger pins
- Supplied as a pair
- Version without center pins
Pinion angle and shim selection
Pinion angle is the angle between the driveshaft and the pinion yoke. On a lifted leaf sprung vehicle, the axle can rotate under torque and push the pinion out of line, which causes driveline vibration and early wear on the U-joints.
Shims work by rotating the axle, so the correct angle depends on how far off the driveline is. Measure the current angle at the pinion and at the transfer case or transmission output, then compare the two before choosing a shim. Caster on the front axle is handled the same way, so measure it when the vehicle is level.
After installation, recheck the angle and inspect the cross-pin for movement. Leaf pack bolts and U-joints should be checked after the first drives, since a shim that settles can change the angle slightly.
- Measure pinion angle at both ends of the driveshaft
- Confirm the shim angle before cutting or drilling
- Check leaf pack bolts after the first drives
- Inspect U-joints for wear after a driveline change
Specifications
| Brand | Warrior |
|---|---|
| Part number | 800051 |
| UPC | 634146800516 |
| Part type | Leaf spring axle shims |
| Angle | 4 degree |
| Width | 2″ |
| Material | Steel, American-made |
| Cross-pin size | Accepts 5/16″ cross-pin; can be drilled for larger pins |
| Cross hole | Counter-bored |
| Center pins | Without center pins |
| Quantity | Pair |
| Warrior fitment label | Universal fit |
Vehicle fitment
Warrior labels the 800051 shims universal fit for leaf sprung Jeeps and trucks. No specific vehicles, model years or chassis codes are named, so the shims are not tied to one vehicle.
Check that your axle has a leaf spring pack, a 2″ wide spring and a matching cross-pin before ordering. No vehicle list is given for the 800051.
Installation notes
The shims attach to the leaf spring pack with the leaf’s cross-pin. This is the version without center pins, so make sure your springs match. A larger cross-pin means the shim hole has to be drilled out.
What’s included
One pair of 4 degree leaf spring shims.















