Overview
The Revtek 426R is a 1.25 inch rear lift block kit with U-bolts, made for rear axles on vehicles with a spring-over axle design. It adds height with blocks and does not increase spring rates.
Key features
- 1.25 inch rear lift height
- Block kit with U-bolts
- Adds height without increasing spring rates
- Designed for spring-over rear axles
Spring-over axles explained
On a spring-over axle the leaf springs sit above the axle tube, so the axle is clamped on top of the spring pack. Blocks fit between the spring and the axle, which lifts the axle without altering spring stiffness. That is why the axle layout is the first factor to check before fitting any block.
Because the spring is unchanged, the ride stays close to stock while the rear rides higher. Inspect U-bolts for thread damage and rust before reuse, and retorque the nuts after the first few drives. Check the spring seats for cracks and wear before the blocks go in.
- Confirm the axle is spring-over
- Inspect U-bolt threads and nuts
- Check spring seats for cracks
- Measure driveline angles after installation
Specifications
| Brand | Revtek |
|---|---|
| Part number | 426R |
| UPC | 811323010092 |
| Lift height | 1.25 inch |
| Included hardware | U-bolts |
| Axle application | Rear, spring-over axle design |
Vehicle fitment
It is marked Direct Fit, and no year, make, model or trim is named for this kit. Fitment depends on the rear axle layout, so confirm your vehicle’s year, model and trim before ordering.
Rear axles with a spring-under layout are outside the stated use. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Install the blocks only on spring-over rear axles. Check driveline angles and shock length after installing the blocks, since any added height changes both.
What’s included
The kit includes U-bolts. Check the number of blocks and U-bolts against your install plan before ordering.








