Overview
The Revtek 731BK is a 2 inch rear lift block kit for rear axles on spring-over designs. It is a block kit rather than a spring replacement, and it adds height without increasing spring rates. Use it only on the spring-over rear axle design it is made for.
Key features
- 2 inch rear lift height
- Does not increase spring rates
- Designed for spring-over rear axles
- Part number 731BK with UPC 70000539831
Driveline and shock considerations
Raising the rear with blocks changes the angle of the driveshaft and the travel of the shock absorbers. Both should be checked once the blocks are in place, since a steeper angle can cause vibration at speed and a shock at full extension can wear faster. Brake lines and the parking brake cable may also need a look because the axle sits in a new position.
Use the kit with the springs already on the vehicle, and check that all related fasteners are in good shape before the first drive. Lift blocks are often installed alongside longer shocks or extended brake lines, so plan those parts together. Retorque the U-bolts after the first few drives and after any trip with heavy loads.
- Check driveshaft angle and slip
- Inspect shock extension at full droop
- Review brake line length
- Retorque U-bolt nuts after initial drives
Specifications
| Brand | Revtek |
|---|---|
| Part number | 731BK |
| UPC | 70000539831 |
| Lift height | 2 inch |
| Axle application | Rear, spring-over axle design |
Vehicle fitment
No vehicle years, makes, models or trims are identified for the 731BK. It is fitted by axle type, so the rear axle design is the deciding factor.
Rear suspensions outside the spring-over design are not covered by the stated use. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Use this block kit only on spring-over rear axles. Raising the rear changes driveline angles and shock travel, so inspect both once the blocks are in place.
What’s included
The block kit contents, including any bolts or U-bolts, are not confirmed. Count the parts against your installation plan before starting.







