Overview
The King Shocks 25001-374A is a 2.5-inch piggyback reservoir adjustable rear shock for the 2018 Jeep Wrangler JL. It is a gas charged shock built as a bolt-on replacement for the JL rear suspension, and King designs it for 2-door and 4-door Wrangler JL models.
The valving is specific to the 18 and newer JL, and each design was developed with real-world testing to set its damping curve and spring rate. The shock is intended for stock height and for vehicles running 0 to 2.5-inch lift kits, and it has an optional wide range compression adjustment.
Key features
- Bolt-on installation for stock and lifted applications
- Fits 0 to 2.5-inch lift kits
- Optional wide range compression adjustment
- Clearly marked billet adjuster knob with 20 positive clicks of adjustment
- Hard anodized aluminum finned reservoir
- Zinc plated 2.5-inch outside diameter shock cylinder
- Valving specific to the 18 and newer JL
- Fully rebuildable and serviceable
Choosing a lift height
Lift height decides how much a rear shock is stretched at full droop and compressed at full bump. Shocks used with a narrow lift range can run out of travel or sit near full extension on taller setups, so the right fit depends on the lift in use. Measure the installed ride height before ordering and compare it against the range the shock covers.
Adjustable rear shocks let you match firmness to load, whether you carry gear, tow, or run mostly empty. Firmer settings suit heavier loads and highway driving, while softer settings work better on rough trails. When the lift changes, the shock’s position and the rear springs both shift, so re-check clearance for the reservoir and wiring at the new height.
Specifications
| Brand | King Shocks |
|---|---|
| Part number | 25001-374A |
| UPC | 700008516781 |
| Shock series | 2.5 piggyback reservoir |
| Cylinder outside diameter | 2.5 inch |
| Shaft diameter | 7/8 inch, hard chromed |
| Reservoir | Hard anodized aluminum, finned |
| Cylinder finish | Zinc plated |
| Charge | Gas charged |
| Compression adjustment | Optional wide range, billet knob with 20 positive clicks |
| Lift compatibility | 0 to 2.5-inch lift kits |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2018 Jeep Wrangler (JL), including Rubicon, Sport, Sport S, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport and Unlimited Sport S trims.
Earlier Wrangler generations, including the JK, are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
It is a bolt-on shock for both stock and lifted applications. Check that the piggyback reservoir clears the body and wiring at your installed ride height.
What’s included
Check the box against part number 25001-374A when it arrives to confirm the contents.









