Overview
The hub is a freewheeling locking hub for 19-spline axle shafts. It is a direct replacement for factory hubs and fits most 1/2 and 3/4 ton Dana 44 and GM 10 bolt axles.
The hub is all metal. G2 says its nodular iron body resists impact, unlike pot metal, and the heat-treated steel locking ring is meant to keep the hub engaged without premature failure. The aluminum cap and dial are there to resist corrosion, and G2 backs the hub with a lifetime warranty.
A freewheeling hub disengages the wheel from the axle shaft when unlocked, so the axle shafts and gears are not turned by the wheels during normal two-wheel-drive driving. The heat-treated lock ring keeps the hub engaged once it is locked.
Key features
- Nodular iron hub body rather than pot metal
- Heat-treated steel locking ring
- Aluminum cap for corrosion resistance
- Alloy dial
- Lifetime warranty from G2
Locking hub maintenance and use
Locking hubs sit between the wheel and axle, so they see road grit, water and heat every time the vehicle is driven. A freewheeling design is most useful when the vehicle is driven mostly in two-wheel drive, since it reduces drag on the front axle. When the hub is locked, the lock ring and dial engage the axle, so it is worth checking engagement before any trail run.
Hubs need periodic attention. Keep the cap seated and the seal clean, and check the hub for play or grinding during engagement. Use the correct lubricant for the hub type, and inspect the lock ring for wear. Because hub service often involves the spindle, check the nut torque and re-check it after the first few miles on a new install.
- Check engagement before trail runs
- Inspect the lock ring for wear
- Keep the cap seated and seals clean
- Re-check spindle nut torque after install
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 89-2033-1 |
| UPC | 631410124170 |
| Spline | 19 splines |
| Hub body | Nodular iron |
| Locking ring | Heat-treated steel |
| Cap | Aluminum |
| Knob material | Alloy dial |
| Finish | Polished aluminum |
| Warranty | Lifetime |
| Fitment | Fits most 1/2 and 3/4 ton Dana 44 and GM 10 bolt axles. |
Vehicle fitment
These hubs fit most 1/2 and 3/4 ton Dana 44 and GM 10 bolt axles. Check your axle type and shaft spline before ordering.
Vehicles with 3-bolt automatic hub covers need spindle nut kit part number D/S28068X. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
These hubs are for 19-spline axle shafts, so confirm the shaft spline first. Three-bolt automatic hub covers require spindle nut kit part number D/S28068X.
What’s included
The G2 locking hub with polished aluminum cap and alloy dial.









