Overview
The Mile Marker hub conversion kit, part number 95-32720, is a spindle nut conversion kit for front axles. It converts factory locking hubs to aftermarket locking hubs on the axles below.
It is a conversion part for the spindle nut area and works with Dana 30 Standard, Dana 44 and GM 10 Bolt 8.5 Inches front axles.
Key features
- Converts factory locking hubs to aftermarket locking hubs
- Spindle nut conversion kit for front axles
- Fits Dana 30 Standard, Dana 44 and GM 10 Bolt 8.5 Inches axles
- Mile Marker part number 95-32720
Locking hub conversion tips
Converting from factory locking hubs to aftermarket units changes how the front axle engages, so the swap should be treated as a full service job rather than a quick part change. The spindle nut area sets the bearing preload, and the hub has to sit squarely on the spindle once the conversion is complete. A hub that is loose or misaligned can wear the spindle threads and the hub seal.
Before starting, clean the hub face and inspect the spindle for grooves or rust. Check the axle seals and wheel bearings while the hubs are off, since replacing them now is easier than returning later. After the swap, confirm the lock engages and disengages fully, and recheck the hub after the first few drives.
- Clean the hub face and spindle before assembly
- Inspect the spindle threads for wear or rust
- Check axle seals and wheel bearings while apart
- Recheck hub tightness after the first few drives
Specifications
| Brand | Mile Marker |
|---|---|
| Part number | 95-32720 |
| UPC | 758626327208 |
| Axle location | Front |
| Axle types | Dana 30 Standard; Dana 44; GM 10 Bolt 8.5 Inches |
| Conversion | Factory locking hubs to aftermarket locking hubs |
Vehicle fitment
Fitment is listed by front axle type rather than by vehicle: Dana 30 Standard, Dana 44 and GM 10 Bolt 8.5 Inches. No model years, makes or models are given.
Confirm your vehicle’s year, model and trim before ordering, and check that your front axle is one of these three types.
Installation notes
Confirm the axle type first, since there are three different front axle designs. Have your aftermarket locking hubs ready before swapping.
What’s included
The kit is the spindle nut conversion part.
Not included: Aftermarket locking hubs are not part of the kit.








