Overview
The Omix-ADA 16527.38 is a front spindle nut kit for the Dana 44 front axle. It includes the inner and outer spindle nuts and the washer, and it is an OE-style, direct-fit kit with a limited five-year warranty.
The kit fits the 1984–1991 Jeep Grand Wagoneer (SJ). Part number 16527.38 covers the full spindle nut set in one part number.
Key features
- Inner and outer spindle nuts included
- Washer included
- OE style, direct fit
- Limited five-year warranty
Before you buy
A spindle nut set holds the wheel bearings at the correct preload on a Dana 44 front axle. The nuts work with the washer to set the bearing position, so the set is best replaced as a unit when threads look worn or the nuts show damage. Loose or worn nuts can allow the hub to move, which shows up as clicking or rough steering feel.
Before installing, clean the spindle threads and check that the nuts run on smoothly without binding. Use a torque wrench and the service procedure for the vehicle, and recheck the bearing setting after the first short drive. Keep the old parts until the new set is confirmed to hold.
- Check spindle threads for damage before fitting
- Run each nut on by hand before tightening
- Recheck the hub after the first short drive
- Replace the set together when one nut is worn
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16527.38 |
| UPC | 804314267445 |
| Position | Front |
| Axle type | Dana 44 front |
| Kit contents | Inner spindle nut, outer spindle nut and washer |
| Warranty | Limited five-year |
| Fitment | Direct fit |
Vehicle fitment
This kit fits the 1984–1991 Jeep Grand Wagoneer (SJ).
Other Jeep models are not in the list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The inner and outer spindle nuts and the washer.









