Overview
It is a 4.30 ratio ring and pinion for the front Dana 60 axle, offered as a reverse thick front set. The pinion turns 4.30 times for each ring gear revolution, a numerically high ratio that multiplies torque at the wheels.
G2 describes its Performance Ring and Pinion line as made for oversized tires and high-performance engines, with current materials and manufacturing. The 4.30 set is identified by the front Dana 60 axle and names no vehicles or model years. Confirm the design with G2 before buying.
Key features
- 4.30 gear ratio for the front Dana 60 axle
- Front axle location
- Reverse thick design.
- Designed for oversized tires and high-performance engines.
- Made with current materials and methods.
Front Dana 60 setup notes
A front Dana 60 gear swap starts with confirming the housing type and the design you need. Reverse thick is a design term, so verify it against your housing before ordering. Once the gears are in hand, check pinion depth, backlash and tooth contact with the correct setup procedure, since those readings decide how the set runs.
A 4.30 ratio multiplies torque at the front wheels, which helps with larger tires and steep climbs. The tradeoff is higher engine speed at highway cruise and more heat through the front axle. Owners who drive the front axle hard should watch the gear oil and the housing temperature, particularly on long grades with a load.
Front axle parts often wear together. Inspect the pinion seal, carrier bearings and axle shafts while the housing is open, and replace any part that shows play, leakage or roughness. Clean the housing before the new gears go in so no metal debris stays behind.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2034-430RX |
| UPC | 631410094152 |
| Axle type | Dana 60 |
| Axle location | Front |
| Design | Reverse thick (per title) |
| Gear ratio | 4.30 |
| Axle manufacturer | Dana |
Vehicle fitment
Confirm that the front housing on your vehicle is a Dana 60 and that the reverse thick design is the one you need. This 4.30 set is made for the front Dana 60 axle, so match the housing before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A front Dana 60 gear swap requires precise pinion depth, backlash and carrier preload, so a gear shop is the usual installer. Allow a break-in period before heavy use.
What’s included
One 4.30 reverse thick ring and pinion set for the front Dana 60 axle, part number 2-2034-430RX.
Not included: Carrier bearings and shims are not included with the 4.30 front set.
















