Overview
The G2 Axle and Gear 4-XJ-410 is a front and rear ring and pinion kit with 4.10 front gears and 4.11 rear gears for the 1984–2001 Jeep Cherokee (XJ). It is for XJs with a Dana 30 reverse front axle and a Dana 35 rear axle, and the kit includes the gear sets and matched master installation kits for the swap.
The rear Dana 35 ratio is 4.11, a hair different from the 4.10 front, and the two are paired in this kit. Both gear sets come with matched master installation kits, and the gears are built for oversized tires and high performance engines.
Key features
- 4.10 front and 4.11 rear gears
- Dana 30 reverse front, Dana 35 rear
- Matched master installation kits
- Fits 1984 to 2001 XJ Cherokee
- Limited lifetime warranty
- Manufactured to O.E. specs
Gear swap considerations
Changing ring and pinion gears alters the final drive ratio, which affects how the Cherokee accelerates, how fast the engine turns at highway speed and how hard the drivetrain works under load. Because the front and rear axles run together in the driveline, both sets should be chosen as a pair so the ratios stay matched. Mixed ratios can cause driveline binding and uneven tire wear.
Gear mesh depends on pinion depth, bearing preload and backlash, and each axle needs those settings made correctly. After the first setup, check the tooth contact pattern with marking compound and recheck backlash once the gears have run in. Carrier bearings and axle seals are often replaced during a gear change because they are disturbed during removal.
- Inspect pinion and carrier bearings for play before reassembly
- Replace axle seals and the pinion seal during the swap
- Check tooth pattern and backlash on both axles
- Confirm speedometer calibration after a ratio change
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-XJ-410 |
| UPC | 700007521711 |
| Product type | Front and rear ring and pinion sets with master installation kits |
| Gear ratio | 4.10 |
| Front axle gears | Dana 30 reverse 4.10 |
| Front carrier | 3.73 and up |
| Rear axle gears | Dana 35 4.11 |
| Rear carrier | 3.54 and up |
| Installation kits | Front and rear matched master installation kits |
| Material | Computer heat treated 8620 steel |
| Manufacturing | Manufactured to O.E. specs, double shot peened, double lapped |
| Warranty | Limited lifetime warranty |
Vehicle fitment
It fits 1984 to 2001 XJ Cherokee models with a Dana 30 reverse front axle and a Dana 35 rear axle. Confirm fit for your vehicle’s year, model and trim before ordering.
The 4-XJ-410 does not cover other Jeep models or other axle combinations. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the 4-XJ-410 spans two axles, set the pinion depth, preload and backlash twice, using the master installation kits. The 4.10 front and 4.11 rear gears are meant to run together, and a trained installer is the normal choice.
What’s included
- Front ring and pinion gear set
- Rear ring and pinion gear set
- Front matched master installation kit
- Rear matched master installation kit
Not included: carriers and parts beyond the master installation kits.









