Overview
The G2 Axle and Gear 3-2189-471 is a 4.71 ratio ring and pinion for the rear Ford 10.00 Inch axle. The pinion turns 4.71 times for each ring gear revolution, a numerically high ratio that multiplies torque at the wheels and suits low-speed pulling.
This Performance Ring and Pinion set is built for oversized tires and high-performance engines, using current materials and manufacturing methods. It covers the 10 inch Ford axle type only, so confirm the housing and carrier on your vehicle before buying.
Key features
- 4.71 gear ratio for the Ford 10.00 Inch rear axle
- Rear axle location
- Ring gear and pinion supplied as one set
- Made for oversized tires and high-performance engines.
- Built with current technology and materials.
Gear ratio and driving
A 4.71 ratio changes how the drivetrain feels in daily use. Engine speed rises faster for each mile per hour, so the engine works harder on the highway and runs at higher rpm than a taller ratio. In exchange, the vehicle pulls strongly from a stop, climbs steep grades and handles heavy loads with less strain on the engine.
Gear sets of this type are usually replaced as a complete package. Bearings, pinion seal, shims and the carrier should be inspected at the same time, since worn carrier parts can make new gears noisy. Check the ring gear bolts and the housing for cracks while the cover is off.
- Check tooth contact with marking compound after install
- Inspect pinion seal and carrier bearings for wear
- Replace worn carrier shims rather than reusing them
- Re-check gear whine after the first few trail runs
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 3-2189-471 |
| UPC | 631410111309 |
| Axle type | Ford 10.00 Inches |
| Axle location | Rear |
| Gear ratio | 4.71 |
| Axle manufacturer | Ford |
Vehicle fitment
The set is for the rear Ford 10.00 Inch axle. Measure the ring gear and confirm the carrier on your vehicle before ordering. A different housing size needs its own matching set.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gear mesh and carrier preload on a 4.71 set require precise measurement, which is why a gear shop is the usual installer. A break-in run is needed before heavy use.
What’s included
One 4.71 ring and pinion set for the rear Ford 10.00 Inch axle, part number 3-2189-471.
Not included: Carrier bearings, shims and hardware are not part of this set.








