Overview
The G2 Axle and Gear 2-2021-308 is a 3.08 ratio ring and pinion for GM 10 Bolt 8.5 inch axles. The pinion turns 3.08 times for each ring gear revolution, a numerically lower setting that keeps engine speed down at cruise.
G2 makes this set for 8.5 inch and 8.6 inch 10 Bolt ring gears, in both front and rear positions. The Performance line is made for oversized tires and high-performance engines, using current materials and methods. Confirm the housing size and axle location on your truck before ordering.
Key features
- 3.08 gear ratio for GM 10 Bolt 8.5 inch axles
- Covers 8.5 inch and 8.6 inch ring gear housings
- Fits front and rear axle locations.
- Ring gear and pinion sold as one set
- Made for oversized tires and high-performance engines.
Setting up the gears
Ring and pinion sets are the gears that set the final drive ratio, so the ratio you choose changes how the truck feels in every gear. A numerically lower ratio like 3.08 keeps engine speed down on the highway, which helps fuel use and quiet cruising. It trades away some low-speed pulling, so drivers who run heavy loads or steep grades should weigh that trade-off first.
Before the gears go in, the carrier and housing need inspection. Look for worn carrier bearing bores, cracked bearing caps and a damaged pinion bearing seat. Gears set up on a worn carrier rarely hold their pattern, so any damage should be corrected first. Fresh bearings and shims are usually replaced at the same time as the gears.
- Inspect the carrier bearing bores before installing
- Replace worn bearings and shims with the gears
- Set backlash and tooth contact with a gear shop
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2021-308 |
| UPC | 631410093513 |
| Axle type | GM 10 Bolt, 8.5 inch or 8.6 inch ring gear |
| Axle location | Front or rear |
| Gear ratio | 3.08 |
| Axle manufacturer | GM |
Vehicle fitment
This set fits GM 10 Bolt axles with 8.5 inch or 8.6 inch ring gears in front or rear positions. Identify the ring diameter and axle location on your vehicle first. Housings outside those sizes are not a match for this set.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Backlash and pinion depth on a 10 Bolt set require measurement, so a gear shop with setup tools is the practical route. Plan for a break-in period before sustained loads.
What’s included
One 3.08 ring and pinion set for GM 10 Bolt 8.5 inch axles, part number 2-2021-308.
Not included: Carrier bearings, shims and hardware are not included with the 3.08 GM 8.5 Inch set and may be needed.
















