Overview
The G2 Axle and Gear 4-XJ5-410 is a complete 4.10 ratio ring and pinion kit for the Jeep Cherokee XJ, covering both the front and rear axles. The XJ chassis code corresponds to Jeep Cherokee model years 1984 through 2001. The pinion turns 4.10 times for each ring gear revolution, a numerically high ratio that multiplies torque at the wheels.
The kit is designed for oversized tires and high-performance engines, built with current materials. It includes front and rear gear sets plus installation kits for both axles.
Key features
- 4.10 gear ratio for the front and rear axles
- Complete kit with gear sets for both axles
- Installation kits for both axles included.
- Designed for oversized tires and high-performance engines
- Made with current technology and materials.
Swapping both axles
Changing front and rear gears in one job doubles the setup work, since pinion depth, backlash and carrier preload must be set on each axle. Lay out the installation kits and check their contents against both axles before the first bolt comes out.
Gear swaps on an older Cherokee often reveal worn axle bearings, seals and mounts, so it is a good time to inspect those parts. Keep the front and rear sets matched in ratio so the drivetrain behaves predictably off road.
After reassembly, make a short break-in run at low speed and re-check fluid levels and bolt torque before using the vehicle for towing or trail work.
- Inspect axle bearings and seals while the axles are open
- Check drive flange and yoke condition
- Keep both axles at the same ratio
- Record shim and preload measurements for reassembly
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-XJ5-410 |
| Axle location | Front and rear |
| Gear ratio | 4.10 |
| Chassis | Jeep Cherokee XJ (1984 to 2001) |
| Kit contents | Front and rear gear sets with installation kits |
| Axle manufacturer | Chrysler |
Vehicle fitment
This kit is matched to the Jeep Cherokee XJ, which covers model years 1984 through 2001. Confirm your chassis code and year before ordering, and confirm the front and rear axles match the units the kit is built for.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A complete front and rear swap involves setting pinion depth, backlash and carrier preload on both axles, and the kit’s installation hardware should be laid out before work starts. Because both axles change at once, a gear shop is the practical route, followed by a break-in run.
What’s included
Front and rear ring and pinion gear sets for the XJ Cherokee, plus the installation kits for both axles.
Not included: Check bearings and shims in the installation kits against both axles before work starts.









