Overview
The G2 Axle and Gear 2-2032-410R is a 4.10 ratio front reverse ring and pinion for the Dana 30 front axle in the Jeep XJ Cherokee from 1984 to 1999 and the Jeep YJ Wrangler from 1987 to 1995. It uses the Dana 30 reverse layout and is made for carriers of 3.73 and up.
G2 says these gears are made for oversized tires and high performance engines. They use computer heat treated 8620 steel with double shot peened and double lapped surfaces, and they are built to O.E. specifications.
Key features
- Dana 30 reverse front ring and pinion
- 4.10 ratio for 3.73 and up carriers
- Made for XJ Cherokee and YJ Wrangler front axles
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Reverse layout and XJ/YJ front axles
A reverse ring and pinion turns the front driveline the opposite way from a standard set, so the gear geometry and the way the pinion sits in the carrier are not interchangeable with a regular Dana 30 gear. Reverse sets are chosen to match the housing and the carrier pattern, and mixing them with the wrong parts can leave the teeth loaded in the wrong place.
On older XJ and YJ front axles, the most useful checks are the pinion bearing preload, the carrier bearing condition and the condition of the axle shaft seals. Shafts and joints of this age often show wear first, so inspecting them when the gears are fitted helps the new set last.
- Confirm the reverse layout matches the housing
- Inspect carrier bearings before fitting
- Check axle seals and joints at the same time
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2032-410R |
| UPC | 631410093896 |
| Gear ratio | 4.10 |
| Axle location | Front |
| Axle type | Dana 30 reverse |
| Popular axle manufacturer | Dana |
| Carrier requirement | 3.73 and up |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
This set is made for the front Dana 30 reverse axle in the Jeep XJ Cherokee from 1984 to 1999 and the Jeep YJ Wrangler from 1987 to 1995.
Confirm your vehicle’s year, model and trim before ordering, especially if it is a Jeep TJ Wrangler, Grand Cherokee or later Wrangler.
Installation notes
Front reverse gears need pinion depth, backlash and bearing preload set by a driveline shop. Run the 4.10 gears through a break-in period once the front axle is assembled.
What’s included
A matched front reverse ring and pinion for the Dana 30 axle.














