Overview
The Daystar Hood Pin Kit KU71104BK is a hood pin kit for fiberglass hoods, built around polyurethane grommets that isolate the hood from its attachment points. Daystar says fiberglass hoods tend to crack around their mounting points without these grommets.
The grommet gives slightly so the fiberglass can flex while still holding the hood firmly in place. The kit is a universal fit.
Key features
- Polyurethane grommet isolates the hood from the mounting point
- Grommet gives so the fiberglass can flex
- Includes a 5/8 inch diameter steel pin
- Stainless steel fasteners attach the grommet to the hood
- Spring retaining clip included
Hood pin basics
Hood pins hold the hood in place at the front and rear, and on fiberglass hoods they also have to allow small amounts of movement. A grommet that is too stiff can crack the fiberglass around its mounting point, while one that is too soft may let the hood shift. Pick pins whose grommets and clips match how the hood is mounted.
Check the grommets for flattening, tearing or hardening every few months, and replace any that no longer hold the hood snugly. Tighten the stainless fasteners after the first few drives, since the hood settles as the grommets seat. If you add or change a hood pin, check that it sits level with the others so the load spreads evenly.
- Inspect grommets for flattening or tears
- Retighten fasteners after the first drives
- Match pin placement across the hood
Specifications
| Brand | Daystar |
|---|---|
| Part number | KU71104BK |
| UPC | 618089003456 |
| Pin | 5/8 inch diameter steel |
| Grommet | Polyurethane |
| Fasteners | Stainless steel |
| Retaining clip | Spring |
| Sold as | Individually |
Vehicle fitment
Universal fit means no specific year, make or model applies. Check that the pins suit your hood and its mounting points before installing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Each pin uses a polyurethane grommet and stainless steel fasteners to attach it to the hood, so the grommet is the part that keeps the hood isolated from its mount. Daystar sells the kit individually because not everyone uses an even number of hood pins.
What’s included
A 5/8 inch diameter steel pin, polyurethane grommet, stainless steel fasteners and a spring retaining clip.









