Overview
The Daystar PA994 is a 2-inch body lift kit for the Jeep Wrangler JK, the 2007 to 2018 Wrangler. A body lift raises the body above the frame without changing the suspension, and this kit is designed to allow use of tires up to 33 inches in diameter on factory rims.
The kit uses high pressure fiberglass reinforced nylon lift blocks and includes a steering extension, ground strap brackets and the hardware needed to install it. It is made in the USA and is intended for automatic transmission vehicles.
Key features
- 2-inch lift for the Jeep Wrangler JK
- Allows use of up to 33-inch diameter tires and factory rims
- High pressure fiberglass reinforced nylon lift blocks
- Steering extension included
- Ground strap brackets included
- High strength hardware included
- Made in the USA
- Intended for automatic transmission vehicles
Before you install a body lift
A body lift sits between the frame and the body, so it raises the body without changing suspension geometry. That also means the steering, brake lines, wiring and shifter linkage may need attention once the body is higher. Inspect the steering shaft and brake hoses after the first drive, and look for pinched wiring near the firewall and body mounts. Retighten the hardware after the first few trail runs, since rubber and nylon parts settle as the vehicle is used.
Tire size matters more with a body lift than with a suspension lift. Larger tires add load to the steering and drivetrain, so keep tire diameter within the stated limit and confirm rubbing at full lock. Body lifts also change the angle of the driveline slightly. If you add heavier bumpers or a winch later, recheck the body mounts and lift blocks because added weight stresses the upper attachments.
- Recheck body mount bolts every few months
- Inspect brake lines and wiring for stretch or chafing
- Confirm tire rub at full lock
Specifications
| Brand | Daystar |
|---|---|
| Part number | PA994 |
| UPC | 618089006327 |
| Lift height | 2 in. |
| Tire diameter allowed | Up to 33-inch diameter |
| Transmission | Automatic |
| Body blocks | Fiberglass reinforced nylon, high pressure |
| Included | Steering extension, ground strap brackets, high strength hardware |
| Country of manufacture | USA |
| Installation time | 3 to 4 hours |
Vehicle fitment
It fits the Jeep Wrangler JK from 2007 to 2018.
It is designed for the Jeep Wrangler JK. Verify fit for your vehicle’s year, model and trim before buying.
Installation notes
Body lifts change how the body sits on the frame, so check the steering, brake lines and wiring after the kit is in. Daystar gives 3 to 4 hours as the time to raise the vehicle.
What’s included
Fiberglass reinforced nylon body lift blocks, a steering extension, ground strap brackets and high strength hardware.









