Overview
The Dana Spicer Dana 44 4.89 Ratio Ring and Pinion, part number 23053-5X, is a ring and pinion gear set for Dana 44 axles at a 4.89 gear ratio. It is available in popular performance and replacement ratios.
Dana Spicer says its ring and pinion gears are the same design that came in Dana axles from the factory.
Key features
- 4.89 gear ratio
- Dana 44 axle type
- Available for front or rear axle locations
- Dana Spicer part number 23053-5X
Choosing a gear ratio
The gear ratio sets how many times the driveshaft turns for each turn of the wheels. A numerically higher ratio gives stronger acceleration and better low-speed pulling, at the cost of higher engine speed on the highway. Because of this, the ratio should match the tire diameter and how the vehicle is driven, whether that is mostly trail use, towing or daily driving.
Changing the ratio also changes speedometer and odometer accuracy, so recalibration may be needed after installation. Tire size changes affect the effective ratio in the same way, so check both together. Ring and pinion sets are usually replaced with new carrier bearings, since worn bearings can disturb gear mesh and preload. Keep a record of the ratio and tire size once the job is complete.
- Confirm the current ratio before ordering
- Check the tire diameter against the new ratio
- Recalibrate the speedometer after installation
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 23053-5X |
| UPC | 23913127961 |
| Axle type | Dana 44 |
| Gear ratio | 4.89 |
| Axle location | Front or rear |
Vehicle fitment
Confirm the axle housing and carrier match before ordering the gears.
Installation notes
A ring and pinion needs professional setup, including gear mesh and backlash, and a break-in period before the axle sees heavy loads.








