Overview
The Dana Spicer Dana 44 Ring and Pinion Kit, part number 706017-21X, is a gear set for Dana 44 axles. Confirm the exact ratio, 4.56 or 4.55, against your current gears before installing the kit.
The gears are built to the same design as the factory gears in the axle. Replacement and performance ratios are available.
Key features
- Dana 44 axle type
- Front or rear axle location
- Kit includes the ring and pinion gear set
Pinion depth and preload
Pinion depth and bearing preload decide how the ring gear meshes with the pinion. If the pinion sits too deep or too shallow, the teeth load at the wrong point, which leads to noise and early wear. Setup usually starts with the pinion shims and the crush sleeve or collapsible spacer, then moves to backlash and the contact pattern.
A shop will typically check the pattern with marking compound and make small shim changes until the teeth contact correctly under light load. Once the gears are running, recheck carrier bolts and pinion nut torque after the first few drives, and listen for whine that changes with speed or load.
- Check backlash at several points on the ring gear
- Confirm pinion shim thickness before final assembly
- Replace the crush sleeve when it has been compressed
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 706017-21X |
| Axle type | Dana 44 |
| Gear ratio | 4.56 or 4.55; confirm before installing |
| Axle location | Front or rear |
Vehicle fitment
Confirm the axle housing and ratio match your current gears before ordering.
Installation notes
Ring and pinion installs need professional setup, including gear mesh and bearing preload. Plan a break-in period after installation.















