Overview
The Dana Spicer 708132-5 is a 4.56 ratio front ring and pinion kit for the Dana 30 axle, with TJ, WJ, XJ and ZJ chassis codes in its title. It is offered for the Dana 30 standard and Dana 30 TJ axle types, and its gears match the factory Dana design.
The kit fits the Jeep Wrangler (TJ) from 1997 to 2006, the Jeep Grand Cherokee (WJ) from 1999 to 2004, the Jeep Cherokee (XJ) from 1984 to 2001 and the Jeep Grand Cherokee (ZJ) from 1993 to 1998.
Key features
- 4.56 ratio front ring and pinion kit
- Dana 30 standard and TJ axle types
- Named for TJ, WJ, XJ and ZJ Jeep chassis
- Matches factory Dana gear design.
- Popular performance and replacement ratio
Dana 30 gear swap basics
The Dana 30 is a light-duty front axle found under older Jeep chassis, and gear changes on it are usually made to suit the tires and the way the vehicle is driven. A 4.56 ratio is a common choice for taller tires because it restores low-speed pulling power. Comparing the axle’s existing ratio before ordering helps avoid a mismatch.
Because a Dana 30 axle is often older, check the pinion seal, carrier bearings and axle shafts before installing new gears. Worn parts can make a new set noisy and shorten its life. Fluid type and level should match the axle’s service requirements once the gears are in.
- Inspect the front axle seals for leaks
- Check U-joints and axle shafts for play
- Confirm drive shaft angles after a tire change
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 708132-5 |
| Gear ratio | 4.56 |
| Axle location | Front |
| Axle type | Dana 30 standard; Dana 30 TJ |
| Popular axle manufacturer | Dana |
| Kit type | Ring and pinion kit |
Vehicle fitment
The kit is for the Jeep Wrangler (TJ) from 1997 to 2006, the Jeep Grand Cherokee (WJ) from 1999 to 2004, the Jeep Cherokee (XJ) from 1984 to 2001 and the Jeep Grand Cherokee (ZJ) from 1993 to 1998.
Confirm your vehicle’s year, model and trim before ordering, especially for other Wrangler generations or Dana 30 reverse layouts.
Installation notes
Pinion depth, backlash and bearing preload on this Dana 30 kit should be set by a driveline shop, followed by a break-in period on the 4.56 ratio.
What’s included
A ring and pinion gear kit for the Dana 30 front axle.












