Overview
The Dana Spicer 707244-5X is a 4.56 ratio ring and pinion kit for the Dana 35 rear axle. Dana Spicer describes its ring and pinion gears as the same gears that came in Dana axles from the factory, and says they come in most popular performance and replacement ratios.
A 4.56 ratio gives more torque multiplication at the wheels than a numerically lower gear such as 3.73. Confirm the axle type before ordering.
Key features
- 4.56 ratio rear ring and pinion kit
- Dana 35 rear axle type
- Matches factory Dana gear design
- Popular performance and replacement ratio
Choosing a ratio
Gear ratio decides how the engine’s turns are spread across the wheels. A 4.56 ratio favors low-speed pulling and towing, while a numerically lower gear suits highway cruising and better fuel economy. If you run much larger tires than stock, the taller tire size effectively lowers the ratio, so factor that in before buying a kit. Think about how you use the rig most of the time.
A kit is a good time to check the rest of the rear end. Carrier bearings, pinion bearings and the pinion seal are often worn by the time gears need replacing, and new gears run best on fresh bearings. Inspect the axle shafts and the housing for leaks, and keep the gear oil at the level the axle requires. After a few trail runs, re-check the bolts holding the carrier and cover.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 707244-5X |
| Gear ratio | 4.56 |
| Axle location | Rear |
| Axle type | Dana 35 |
| Popular axle manufacturer | Dana |
| Kit type | Ring and pinion kit |
Vehicle fitment
Pick the axle type and gear ratio that match your housing before ordering.
Dana 35 gears are a different axle from the Dana 30, Dana 44 and Dana 60 layouts, so confirm the axle name on the housing. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload for this kit should be set by a driveline shop, followed by a break-in period on the 4.56 ratio.
What’s included
A ring and pinion gear kit for the Dana 35 rear axle.








