Overview
The Camburg CAMCAM-010048 is a uniball rebuild kit for the upper control arms Camburg Engineering builds. It supplies the two FK 1.25 uniballs and two snap rings needed to rebuild the uniball joints in those arms, so the joints can be restored without replacing the whole arm.
The uniballs are made in the USA. Each one has a self-lubricating military grade PTFE liner that reduces stiction and noise inside the joint. The uniballs carry a 100,730 lbs load rating and are built to carry more load than OEM style ball joints and smaller uniball bearings.
Key features
- Two FK 1.25 uniballs and two snap rings in the kit
- Self-lubricating military grade PTFE liner for reduced stiction and noise
- Made in the USA
- Load rating of 100,730 lbs.
- Rebuilds the uniballs in Camburg upper control arms
Before you rebuild the joints
A uniball joint carries the load between the arm and its mounting point, so play in it shows up as a loose or clunking front end. Before rebuilding, support the arm safely, check the joint by hand for movement, rough spots and binding, and clean the housing thoroughly so no grit remains against the new liner.
Rebuilding is most useful when the ball and housing are still sound and the wear is limited to the liner. If the ball is pitted, the housing is cracked or the arm is bent, a rebuild will not solve the problem and the arm should be replaced. Mark the orientation of parts before disassembly, and recheck the retaining hardware after the first few drives.
- Look for grit or corrosion in the housing before fitting the new uniball
- Replace the snap rings whenever the joint is opened
- Use the torque the workshop manual gives for your vehicle
Specifications
| Brand | Camburg Engineering |
|---|---|
| Part number | CAMCAM-010048 |
| Uniball size | FK 1.25 |
| Quantity | Two uniballs and two snap rings |
| Liner | Self-lubricating military grade PTFE |
| Load rating | 100,730 lbs |
| Made in | USA |
| Older arm versions | Some use a smaller 1.00 inch uniball |
Vehicle fitment
The kit is made for Camburg upper control arms, so fit depends on the arm version and its uniball size rather than on a truck model.
Confirm the arm version and uniball size before ordering, because some older arm versions take a smaller 1.00 inch uniball. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The uniballs are the moving parts of the arm, so check the arm version and uniball size before starting the rebuild. The kit includes two snap rings to match the two uniballs.
What’s included
Two FK 1.25 uniballs and two snap rings.
Not included: the Camburg upper control arms. The kit is for rebuilding the uniballs in arms you already have.










