Overview
The Bushwacker 31928-02 is a set of four pocket style fender flares, titled for the Toyota Tacoma. The set covers both the front and rear wheel openings, with 2 inches of width and tire coverage. Bushwacker presents it as a bolt-on pocket flare built from Dura-Flex 2000.
The matte black surface is OEM style, UV protected and paintable, so it can stay black or be painted to match the body. The flares are made from Dura-Flex 2000, a material that resists chalking. The vehicle this set is built for is not settled, so confirm fit for your own year, model and trim first.
Key features
- Pocket style flares with recessed stainless steel bolts
- Front and rear positions in one set of four
- 2 inches of width and tire coverage
- Minimal drilling needed for installation
- Dura-Flex 2000 that Bushwacker describes as thick and flexible
- OEM matte black finish that is easy to paint
Measuring before a flare install
Accurate measurement comes first with any pocket style flare. Check the distance from the center of the hub to the outer fender edge on each wheel, then compare that with the flare width. Tire size, load and suspension height all change the result, so take measurements with the truck parked on level ground and the tires at their normal pressure.
Pocket flares are held by recessed bolts, so the work is mostly about alignment rather than cutting. Set the flare in place, hold it with tape, and step back to check that the edges line up with the body on both sides. Small gaps are easier to correct before the hardware is fully tightened than after paint has been applied.
Keep the finished appearance in mind. Matte black Dura-Flex can be painted, but the first coat needs a plastic primer and a light scuff to bond. Paint the flares away from the truck when possible to avoid overspray on the body.
- Measure both sides, not just one
- Tape the flare in place before drilling
- Re-check alignment after the first drive
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 31928-02 |
| UPC | 9068911613 |
| Position | Front and rear |
| Width and tire coverage | 2 inches |
| Quantity | Set of 4 |
| Fit type | Direct fit |
| Material | Dura-Flex 2000 |
| Finish | OEM matte black, paintable |
Vehicle fitment
Both a Toyota Tacoma and a Jeep Wrangler apply to this design, and no model years are set, so the correct vehicle has not been established. Match the vehicle to your own truck before choosing this set.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The install is minimal drilling. Because the vehicle is unclear, compare the bolt locations with your own truck before drilling any holes.
What’s included
One set of four pocket style fender flares for the front and rear.















