Overview
The Bilstein 25-242379 is a rear left 5160 Series reservoir shock absorber for the 2005–2018 Toyota Tacoma. It mounts in the stock shock location with no cutting or welding required. It is a gas charged, mono tube shock with a remote reservoir, rated for 0 to 1.5 inches of lift.
The 5160 Series is a reservoir shock for pickups and SUVs, built for off-road and on-road use. The remote reservoir adds shock oil capacity for greater heat dissipation and damping sensitivity, and the floating dividing piston inside the reservoir allows more wheel travel and shaft movement.
Key features
- Remote reservoir increases shock oil capacity for greater heat dissipation and damping sensitivity
- Digressive valving system that produces full damping capability right away
- Mono tube internal design
- Floating dividing piston located in the reservoir for increased wheel travel
- Reservoir mounting configuration designed for each vehicle application
- Triple-C Technology finish for easy care and lasting appearance
Installing a reservoir shock
A reservoir shock mounts with extra hardware that has to be routed and secured carefully. Before lifting the truck, lay out the upper mount kit, reservoir mount kit and instructions, and check that the reservoir can sit clear of the frame, brake lines and wheel well at full compression.
Keeping the reservoir away from heat and debris matters. Position it where road spray and mud are not packed against it, and use the mounting points the kit provides rather than improvised brackets. A reservoir that rubs against a tire or frame will wear through its finish and can be damaged over time.
- Test full compression and extension by hand before final tightening
- Check the threaded stem and nut for correct seating
- Keep the reservoir hose free of kinks and sharp edges
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 25-242379 |
| UPC | 651860750262 |
| Shock series | 5160 Series |
| Position | Rear left |
| Fitment type | Direct fit |
| Lift height | 0 to 1.5 in. |
| Collapsed length | 14.22 in. |
| Extended length | 24.06 in. |
| Travel length | 9.84 in. |
| Lower mount | Eye, 12.1mm |
| Upper mount | Stem |
| Shaft diameter | 14mm |
| Body design | 46mm ID smooth body (non-coilover) |
| Internal design | Mono tube |
| Hydraulic / gas charged | Gas charged |
| Reservoir | Yes |
| Finish | Zinc plated |
| Boot included | No |
Vehicle fitment
It fits the 2005–2018 Toyota Tacoma in the Base, Limited, Pre Runner, SR, SR5, TRD Off-Road, TRD Pro and TRD Sport trims. This part is for the rear left position only.
Years before 2005 and from 2019 onward fall outside this fit, and other Toyota models are not included.
Installation notes
The shock installs in the stock shock mounting location with no cutting or welding. Follow the included instructions for the reservoir mount. Support the vehicle safely on jack stands before removing the original shock.
What’s included
Upper mount kit and reservoir mount kit, along with detailed instructions.
Not included: Dust boot, since the shock is listed with no boot included.









