Overview
The Bilstein 24-185165 is a front monotube gas-charged shock absorber from the 4600 Series, with a 2 in body diameter and a yellow finish. It carries a 0 in lift/drop rating, so compare that figure with your vehicle’s suspension height. No vehicle is named for this part, so confirm the application before ordering.
The monotube body uses a dividing piston that lets the oil expand as it heats, which helps prevent foaming and keeps damping consistent. The extruded tube is built to tight peak-to-valley tolerance, and the shock body helps move heat away from the oil. The piston head allows compression and rebound to be tuned independently, and the design uses fewer parts than conventional twin tube and road sensing shocks.
Key features
- Front position in the 4600 Series monotube line
- Gas-charged monotube body with a dividing piston
- Extruded tube with tight peak-to-valley tolerance
- Piston head allows separate compression and rebound tuning
- Lift/drop rating of 0 in
- Dust boots included
Choosing a front shock
A front shock absorber controls how the suspension compresses and rebounds over bumps, and it works alongside the springs to keep tires in contact with the ground. A monotube design keeps the damping oil and gas charge in one tube, so the body can shed heat more evenly during long descents and repeated trail runs. Good damping matters most when a truck is loaded, towing or running larger tires, because the front axle carries much of the braking and steering load.
Shocks wear gradually, so look for oil leaks on the body, a dented tube, cracked or split dust boots, and a bouncy front end that keeps moving after a dip. Replace shocks in pairs on the same axle so both sides damp evenly. When a front end has been lifted, check the mounting points and extended length against the new geometry, and inspect related parts such as bushings and boots at the same time.
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-185165 |
| UPC | 651860414188 |
| Shock series | 4600 Series |
| Position | Front |
| Type | Monotube, gas charged |
| Body diameter | 2 in |
| Lift height | 0 in lift/drop |
| Reservoir | No |
| Boots included | Yes |
| Finish | Yellow |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct-fit design. Confirm fit for your vehicle’s year, model and trim before ordering.
Rear and other 4600 Series shocks carry different part numbers and are not covered by this front entry. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rating is 0 in lift/drop, so a front end that has been raised falls outside the stated figure. Check your front suspension height before fitting this shock.
What’s included
One front shock absorber with dust boots.
Not included: the opposite front shock, which is a separate part.









