Overview
It is a rear B8 5100 Series shock absorber for lifted Jeep Wrangler models. It fits 2004 to 2006 Wrangler LJ, including Unlimited and Unlimited Rubicon, and 1997 to 2006 Wrangler TJ in 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
It is designed for up to a 2 inch rear lift, with a collapsed length of 12.81 inches and an extended length of 19.96 inches. It uses a monotube design with a velocity-sensitive, digressive piston and is a direct-fit solution for lifted trucks and SUVs.
Key features
- Rear position
- Designed for up to a 2 inch rear lift
- Monotube design with a velocity-sensitive, digressive piston
- 46 mm smooth body with a zinc-plated finish
- The monotube body is built for steady damping over repeated use.
Choosing the right setup
Lifted Wranglers change the length a shock must cover, so the collapsed and extended lengths matter as much as the mounting style. A shock that is too short can run out of travel at full droop, and one that is too long can bind at full compression. Compare both lengths with your current unit, and check the bump stops and rear control arm angles at the same time.
A lift also shifts how the rear axle moves under acceleration and braking. Sway bar end links, brake lines and driveshaft angles may need attention on a higher stance. A monotube body keeps damping steady as it heats, which is useful on trails and on pavement where the rear end carries load.
- Compare collapsed and extended lengths before buying
- Inspect bump stops for wear
- Check brake lines and driveshaft angles after the lift
Specifications
| Brand | Bilstein |
|---|---|
| Part number | BIL24-293105 |
| Series | 5100 Series |
| Position | Rear |
| Lift | Up to 2 inches |
| Shock type | Monotube |
| Collapsed length | 12.81 inches |
| Extended length | 19.96 inches |
| Body | 46 mm smooth body |
| Finish | Zinc plated |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2004–2006 Jeep Wrangler LJ in Unlimited and Unlimited Rubicon models, and the 1997–2006 Jeep Wrangler TJ in 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X models.
The list covers only LJ and TJ Wranglers in the years named. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure the collapsed and extended lengths of the original rear shock and confirm the lift is up to 2 inches before fitting. Work on a securely supported vehicle.
What’s included
One rear shock absorber.









