Overview
The Baer Brakes 6801302RP is a Remaster master cylinder with a 1 inch bore, right side outlet ports and a 4-bolt Mopar firewall flange, finished with a polished billet body. It is a compact, one-piece unit machined from 6061 T6 billet aluminum, aimed at early Mopar brake systems that run a power booster or a manual pedal.
Two large knurled caps sit on the billet top, which is held by 6 allen screws, so fluid can be added without spilling. Outlets use a 3/8-24 thread and take inverted flare fittings with removable brass seats, or banjo style and straight fittings. It is compatible with most long and short booster or manual applications, and optional proportioning valves are also available.
Key features
- Fully machined one-piece 6061 T6 billet aluminum body
- Right side ports with a 3/8-24 outlet thread
- Removable seats for inverted flare, with banjo and straight fitting options
- Knurled caps with a screw-on design for spill-free filling
- Polished finish on the body, caps and lid
- 4-bolt Mopar firewall mounting bracket
Caring for a polished finish
A polished billet body shows fingerprints, road grime and fluid spots more readily than a painted or anodized surface. Clean it with a mild soap and water, then dry it with a soft cloth. Avoid abrasive pads or strong solvents, which can dull the finish and leave hazy marks around the caps and lid.
Fluid that drips onto the body should be wiped off promptly, since brake fluid can damage the paint on nearby panels. Inspect the caps, the lid and the outlet fittings whenever you check the fluid level. A seep around a fitting is an early sign that a seat or tube nut needs attention.
- Wipe spills off right away
- Use mild soap and a soft cloth
- Inspect fittings for seepage at each fluid check
- Avoid abrasive pads on the billet
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801302RP |
| UPC | 844165052135 |
| Series | ReMaster |
| Bore size | 1 inch |
| Body material | 6061 T6 billet aluminum |
| Body finish | Polished |
| Cap and lid finish | Polished |
| Flange type | 4 bolt Mopar |
| Master cylinder port exit | Right side |
| Outlet port size | 3/8-24 inch |
| Outlet port quantity | 2 |
| Outlet port fittings | Banjo without brass seat, 3/16 inch inverted flare and tube nuts with brass seat |
| Removable seats | Yes |
| Reservoir | Integral, dual, 6061 T6 billet aluminum |
| Reservoir size | 7 oz per reservoir; fill to 75 percent or 5.25 oz per reservoir |
| Stroke | 1.1 |
| Master cylinder cap | Included |
| Country of origin | USA |
| Sold as | Each |
Vehicle fitment
This unit targets early Mopar cars that use a 4-bolt flange. Verify the flange pattern and 1 inch bore against your original setup, and verify your vehicle’s year, model and trim before you place the order.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The two brass seats and two tube nuts that come in the box suit the inverted flare outlets, so settle on the fitting type before tightening any lines. Bleeder screws, bleeder hoses and mounting hardware are not supplied, so gather them before starting the install.
What’s included
A single polished Remaster master cylinder unit with its cap, two brass seats and two tube nuts. The integral dual reservoir is part of the assembly.
Left out of the kit: mounting hardware, any sensor, the brake pressure switch, a gasket or seal, and the brake booster along with bleeder screws and hoses.














