Overview
The Baer Brakes 6805203 is a Remaster brake master cylinder kit that combines a black ReMaster master cylinder, a matching adjustable proportioning valve and pre-bent hardlines in one assembly. It is built for brake upgrades on manual or power brake setups that need finer brake balance control.
Baer Brakes machines the master cylinder and proportioning valve from 6061 T6 billet aluminum, with a 15/16 inch bore and left-side outlet ports. The compact layout clears space around the firewall. Confirm the bore, port layout and mounting pattern against your current brake system before installation.
Key features
- Black ReMaster master cylinder with left-side outlet ports and a two-bolt mount
- Adjustable knob-style proportioning valve with an integrated mounting block
- Pre-bent 3/16 inch hardlines with 3/8-24 inverted flare fittings
- Machined and knurled screw-on caps for filling without spillage
- Black anodized finish on the master cylinder body, lids and proportioning valve
- Integral dual reservoir with removable seats
- Fully machined 6061 T6 billet aluminum construction
- Made in the USA
Choosing a master cylinder setup
A proportioning valve controls how much brake pressure reaches the rear circuit compared with the front. Adjusting it changes the balance between the two axles, which matters when a brake upgrade adds stopping power up front or when a vehicle is heavier than stock. Make small changes and test the pedal feel in a safe area before relying on the setting.
Hardline work often shows up alongside a master cylinder swap. Lines that are pre-bent should be routed and held in clamps before fittings are tightened, so nothing is stressed at the cylinder. After any brake work, bleed the system fully and inspect each joint for seepage. Check the fluid level in the reservoir regularly, because worn seals and low fluid are common reasons for a soft pedal.
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6805203 |
| UPC | 90127856079 |
| Series | Remaster |
| Sold as | Kit |
| Bore size | 15/16 inch (0.9375) |
| Master cylinder material | 6061 T6 billet aluminum |
| Finish | Black anodized |
| Reservoir | Dual, integral, 6061 T6 billet aluminum |
| Master cylinder outlet ports | 2, 3/8-24 inch, left side |
| Master cylinder outlet fittings | 3/16 inch inverted flare with tube nuts and brass seat |
| Mounting holes | 2 |
| Proportioning valve | Adjustable, knob style, aluminum, black anodized |
| Proportioning valve ports | 3/8-24 inch inlet and outlet, 3/16 inch inverted flare fittings |
| Proportioning mounting block | Integrated, aluminum, 2 holes |
| Hardlines | 3/16 inch pre-bent, 3/8-24 inverted flare fittings |
| Country of origin | USA |
Vehicle fitment
It uses a two-bolt GM/Ford firewall mounting bracket. Confirm the year, model and trim of your vehicle match the kit before ordering.
Confirm your vehicle’s year, model and trim before ordering. Check the bore, port layout and firewall mounting pattern against your existing brake system.
Installation notes
The proportioning valve mounts beneath the ReMaster master cylinder on its integrated block, and the block hardware is included. The two-bolt firewall bracket and master cylinder mounting hardware are not included, so they must be sourced separately. Because the hardlines are pre-bent, test-fit them against the master cylinder and proportioning valve before tightening any fittings.
What’s included
The kit includes 1 master cylinder assembly and 1 proportioning valve, with fittings, a master cylinder cap and proportioning mounting block hardware. Pre-bent hardlines are included.
Not included: brake booster, brake pressure switch, sensor, gasket or seal, mounting bracket and mounting hardware.

















